Do You Like Beach Balls?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • inbox_pm
    Senior Member
    • Apr 2017
    • 189

    #61
    Originally posted by heaviest

    Probably nobody's following this, but the woman was on the ball an hour and a half and it sprung another leak. Another pinhole leak on the pole where it is welded over the joining of two side panels. So, it's been patched AGAIN. There are now four patches on the top and one on the bottom. Only two more intersections of pole and side panels at the top pole that haven't already been patched.
    It's a known weak place of all balls. I usually put a ball "vertically" during play to reduce a loads on these places. On a transparent balls you even can see how a main seam begin to rip under the pole, then this rip going to a pole round seam and a hole appears.

    Originally posted by heaviest
    I'm cutting small round pieces of donor vinyl, in white, and this ball has white polka dots on three of the side panels, so it looks like some of those dots have migrated to the poles lol.
    Yes, it's a "radical" reinforce, after this a ball can pop only on one of the main seams.

    Originally posted by heaviest
    Anyway, we have established that the ball doesn't stretch forever, or at least it slows down a lot. She did add air for about the fourth time at about an hour and a quarter, so it was still stretching, but slowly. I figure if we ever get to the point where it lasts two hours without springing another leak, we can say she used it as a chair and not just a toy.
    It depends from a temperature. In a hot weather vinyl becomes much softer and stretches much bugger under the same load.


    Comment

    • heaviest
      Senior Member
      • Jun 2018
      • 914

      #62
      Originally posted by inbox_pm
      On a transparent balls you even can see how a main seam begin to rip under the pole, then this rip going to a pole round seam and a hole appears.
      On the Walmart 36 inch ball, the poles are stretched so much I can see through them pretty well. The panels are not cut strait, or evenly, and the pole isn't aligned very well. It looks like pretty sloppy assembly. The round weld that holds the whole thing together comes right to the edge of one of the panels. And the pole vinyl seems to be thinner than the side panels.

      I had patched up the fourth hole in the top pole and it looked like a fifth was just about to start leaking, so I patched that one, too. There's a sixth one forming, and another one about a half inch from that one, but without patching those, the 250 pound woman was then on the ball for over two hours, and it has not sprung another leak!

      She sat at my desk on the ball, with a keyboard in her lap for much of the time. For the first hour she had her legs extended, balanced on the ball, stretching her hip flexors and hamstrings and exercising her core. But her back began to ache and one of her hip flexors was starting to ache, so she spent the next half hour with her legs crossed at her ankles, still balancing with her feet off the floor, and then went back to extending her legs. She says it was a good exercise but it was boring. She got a lot of work done at the same time, though. Not sure she wants to do that anymore.

      The ball gets big enough around when she's on it that if she sits slightly off-center there's room for her to balance with her feet off the floor, even while she's relaxed. When she got up that round stretched and puckered part under her butt was very off-center and the ball was lopsided. There were damaged-vinyl stretch marks starting to form around the equator. The top pole is oblong, and the bottom one is very irregular-shaped and the six panels are aligned all askew. And we have the proper amount of air in it, probably more than twenty breaths past full, done while it is stretched, so that when she gets off the ball it eventually recovers but still appears to be fully inflated. It has stretched, but isn't still stretching. Maybe a little bit. We'll probably add another breath or two next time.

      Fully recovered the ball is as big around as a 42 incher, but not as tall. Almost as tall, though. It has definitely been permanently stretched, and flattened a bit. The whole thing is also slightly oblong while viewed from the top. And of course there are the patches, and the stretched and irregular, translucent poles. I love the look of an inflatable that has seem some abuse.

      Comment

      • heaviest
        Senior Member
        • Jun 2018
        • 914

        #63
        She was on the Walmart 36 inch ball again for a couple hours. I didn't measure it precisely, but with my hand I determined the individual panels stretched to about 20 inches, each, or 120 inches around, from 72-ish. From already stretched and fully inflated from the previous session, we added 8 more breaths of air over two hours. Possibly it was starting a runaway stretch, or possibly we were tougher on it than we should have been.

        It got big enough that she sat with her legs outstretched, feet off the floor, completely relaxed. Didn't have to lift them off the floor. On a 36 inch ball!

        My takeaway, from trying to get long-term use out of such a simple toy...

        I'm surprised it stretched so much without developing another leak. There are currently five patches on the top pole and one on the bottom, and none on the side seams. There are a couple more places that look like they'll need patches eventually, but we've gotten two long sessions since it was last patched!

        But I'm also disappointed that it stretches so much and needs so much patching with just 250 pounds on it. I'm curious what y'all do to preserve your toys and get repeated use out of them, and might ask in another post.
        Last edited by heaviest; 24-07-2024, 17:25.

        Comment

        • Latorex
          Yoga ball lover
          • Jul 2024
          • 37

          #64
          Yes i do like popping them since they are easy to pop unlike a balloon i use for effort to popping it so i can get pleasure and satafation at the same time when the beach ball pops
          A Exercise ball lover since 2nd grade of school!
          A Expert on "How to use a yoga ball" since Middle School
          I don't like popping yoga balls!

          Comment

          • inbox_pm
            Senior Member
            • Apr 2017
            • 189

            #65
            Originally posted by Latorex
            Yes i do like popping them since they are easy to pop unlike a balloon i use for effort to popping it so i can get pleasure and satafation at the same time when the beach ball pops
            A ball pop is fully controllable, if it's new and good quality Even a way how it will pop, a slow hissing or a loud bang.

            Comment

            • puffy cheeks
              inflatable lover
              • Nov 2013
              • 243

              #66
              I also like the pressure of the tightness of the beachball pushing against my lips, as I push back trying to get more air in, with my hands on both sides of the beach ball

              Comment

              • Malakai93
                Senior Member
                • Sep 2018
                • 139

                #67
                I Love beach ball's! Have you tried the SPH ball from Shosu?
                Attached Files

                Comment

                • heaviest
                  Senior Member
                  • Jun 2018
                  • 914

                  #68
                  Originally posted by heaviest
                  There's a large, translucent ball in yellow, orange and red, with an unusual patch-like seam pattern rather than the symmetric pattern of most other balls, that keeps showing up in pron films. I assumed it was sold as a sex toy, but it turns out it's just a Sun Splash 48 inch ball. Old and hard to find, but nothing special, construction-wise. As far as I know.
                  There's a yellow one on ebay selling for over $200, with 10 people watching it, lol. I understand some people are interested in it as vintage and collectible, but I've seen these in so many pron films I'm wondering if there's some special attraction. Perhaps because it's entirely translucent? Shosu sells translucent balls, don't they? So it must be the irregular seams?

                  Anyway, it's common in these films that after they're done with it they poke a hole in it with their fingers and pretend it popped because they were rough with it, though in reality they weren't rough at all. Got most of their combined weight on it only briefly. Lame. But in retrospect, given how desirable these balls seem to be, it's a shame they pop them with their fingers.

                  Anyway, the heaviest couple I've seen on one of these is perhaps 500 pounds between them. She's about 250 pounds and on her back on the ball with her feet in the air, so her weight is fully on the ball, and he's about 250 pounds but at best just leaning on her. Most of his weight remains on his feet. Maybe for about 20 seconds he gets maybe 2/3 his weight on her. The ball does flatten quite a bit for those 20 seconds. The best 20 seconds of the film. They're on a tile floor, so potential consequences if it does pop!

                  I just wish more people would do videos of couple on beach balls, but dammit, put your weight into it!

                  In video I've seen 600 pounds on the Intex 42 inch ball, but just briefly. In the flesh I've seen well over 700 pounds on one of these. I've described those experiences here.

                  I'd still love to see a large ball that was made to hold the weight of two adults. I still haven't heard whether there's anything special about the Shosu balls. Are they or aren't they made to take the weight of 2 adults? I suspect not.
                  Last edited by heaviest; 26-11-2024, 09:55.

                  Comment

                  • heaviest
                    Senior Member
                    • Jun 2018
                    • 914

                    #69
                    Originally posted by heaviest
                    She was on the Walmart 36 inch ball again for a couple hours. I didn't measure it precisely, but with my hand I determined the individual panels stretched to about 20 inches, each, or 120 inches around, from 72-ish. From already stretched and fully inflated from the previous session, we added 8 more breaths of air over two hours. Possibly it was starting a runaway stretch
                    I posted an update on this ball in another thread. When the weather turned colder she was on it for all of five minutes and it developed at least three leaks. I patched two leaks on the outer seams and it's still leaking somewhere.

                    Comment

                    • heaviest
                      Senior Member
                      • Jun 2018
                      • 914

                      #70
                      Originally posted by Benjy
                      There seem to be a few knock-off versions of the one with end-to-end stripes, but arguably one I have is nicer than the Intex version (mainly because the Intex one has white reverses to the coloured stripes, the knock-off has colours both inside and out, so it's a bit more decorative).
                      FWIW I found in the reviews of the Intex 42 inch polka dot ball, sold as a set of 4, people complaining that they received the striped one, instead. The photos seem to show colored reverse, but someone photographed the packaging, and it was Intex packaging, and the ball itself has the Intex brand on it. If it's a knock off, it's an actual knock off (someone pretending to be Intex) and not just someone making a look-alike with another brand. People were receiving the striped ball as late as 2023. Amazon seems to get listings crossed, so there's no telling if the current listing is the same seller or even the same product as the 2023 reviews.

                      Curious. I'm not a collector. I wouldn't be happy that someone was selling knock-offs, but if I received the striped knock-offs and they were good balls, I wouldn't be too disappointed.

                      Comment

                      • Bobolooner
                        Member
                        • Mar 2023
                        • 47

                        #71
                        I've started making inflatable shorts from beachballs. They feel great and it's quite easy to do. 😀

                        Comment

                        • bagr
                          Junior Member
                          • Jul 2013
                          • 28

                          #72
                          beachballs r 1a da most SEXY inanimate objects in xistance

                          Comment

                          • puffy cheeks
                            inflatable lover
                            • Nov 2013
                            • 243

                            #73
                            Originally posted by SuTeKh
                            I Love beach ball's! Have you tried the SPH ball from Shosu?
                            I have one, it's pretty awesome, however I found out last time I used it they can't take overinflation. it got a seam leak as I was trying to make it rock hard. I patched it with some gorilla tape

                            Comment

                            • Vicci
                              Blown to bits
                              • Oct 2009
                              • 816

                              #74
                              Shosu stuff can be a bit hit and miss. I've had some of their items inflated so hard they ring like a bell, but others get a seam leak whilst still really soft. Had a batch of items last year from them where an entire seam hadn't been welded (they replaced them no questions - and checked the replacements before sending them).
                              Vicci x

                              Comment

                              • Malakai93
                                Senior Member
                                • Sep 2018
                                • 139

                                #75
                                My first shosu sph ball held up great i overinflated it and sat on it with full weight no problems except the sph developed a leak But yeah they are hit or miss cause i bought a brown bunny roll and on the 2nd ride it split a seam right on its head that connects to the body I do love their ride rolls tho

                                Comment

                                Working...