Is there a way to pop so that the balloon only breaks into just a few pieces?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Guest

    Is there a way to pop so that the balloon only breaks into just a few pieces?

    I'll soon travel to a place where I can only loon in the woods where no-one can see me. I like to pop, so I'd like to ask - is there a way to pop balloons without shredding them into a thousand pieces? If that were to happen, it would be impossible to pick all the pieces up, and the last thing I want is to litter the woods
  • lukmanrewa
    Senior Member
    • Jun 2012
    • 491

    #2
    Only popping them with a sharp object guarantees that.

    If you do a b2p, stomp or sit on them where the bang is louder, it is more than likely it will end up with multiple smaller shreds.

    Comment

    • Guest

      #3
      Not sure if there's any truth to this, but I have heard that if you pop it with a pin right at the top of the balloon you are more likely (but not guaranteed) to get a single piece. I think its because the latex is typically thicker there.

      Edit: Tried it on a couple this morning. Here are the results. More than 1 piece each, but not fragments, and they were extremely overinflated. Interestingly, when you pin the top you get a fraction of a seconds delay when you feel the pin go in before it bursts. A bit like the trick where you put sellotape on the balloon and pierce that, but less of a delay.
      Attached Files
      Last edited by Guest; 07-07-2025, 09:56.

      Comment

      • Loon119
        Senior Member
        • Jun 2018
        • 494

        #4
        Are you wanting to b2p or just pop? If just wanting to pop would a blanket over them or inside a garbage bag help contain the shreds. I have found if I sit pop a balloon that's smaller than my butt it gets contained more. As opposed to when the wife sit pops 16"+ and the neck flies one way and shrapnel the other

        Comment

        • 7balloon
          One of the First Online
          • Dec 2018
          • 683

          #5
          the tighter the balloon when it breaks, the more pieces there are. And stay away from metalics. those shred very easily.

          Comment

          • TheBigPoolCat
            Senior Member
            • May 2025
            • 163

            #6
            Make sure its underinflated. Many pieces are a sign that the balloon was under a lot of strain when it popped. When that is the case its easier for more of the latex to crack and split it apart.

            Comment

            Working...