I'll soon travel to a place where I can only loon in the woods where no-one can see me. I like to pop, so I'd like to ask - is there a way to pop balloons without shredding them into a thousand pieces? If that were to happen, it would be impossible to pick all the pieces up, and the last thing I want is to litter the woods
Is there a way to pop so that the balloon only breaks into just a few pieces?
Collapse
X
-
GuestTags: None😞 1 -
Only popping them with a sharp object guarantees that.
If you do a b2p, stomp or sit on them where the bang is louder, it is more than likely it will end up with multiple smaller shreds. -
Guest
Not sure if there's any truth to this, but I have heard that if you pop it with a pin right at the top of the balloon you are more likely (but not guaranteed) to get a single piece. I think its because the latex is typically thicker there.
Edit: Tried it on a couple this morning. Here are the results. More than 1 piece each, but not fragments, and they were extremely overinflated. Interestingly, when you pin the top you get a fraction of a seconds delay when you feel the pin go in before it bursts. A bit like the trick where you put sellotape on the balloon and pierce that, but less of a delay.Attached FilesLast edited by Guest; 07-07-2025, 09:56.👍 1Comment
-
Are you wanting to b2p or just pop? If just wanting to pop would a blanket over them or inside a garbage bag help contain the shreds. I have found if I sit pop a balloon that's smaller than my butt it gets contained more. As opposed to when the wife sit pops 16"+ and the neck flies one way and shrapnel the other😀 1Comment
-
Make sure its underinflated. Many pieces are a sign that the balloon was under a lot of strain when it popped. When that is the case its easier for more of the latex to crack and split it apart.Comment
Comment