i found large ldpe bags measured 2000 x 2400 MM. However it would be IMPRACTICAL to tie one at the end, would look ugly and hard to use with all the folds coming from tying the bag.
So i thought maybe i can weld two of them together, cut one corner of the bag, stick a valve to it and make a GIANT ride roll.
Now why would i do this?
-my country does not have those 45"-60" balloons which i really want
-international delivery is expensive and takes a long time
-i'm not into animal shaped inflatables
-ldpe doesn't weaken after a couple inflations, so it's more reliable than balloons
What i don't like about this is that it won't shine or have that nice glossy balloon texture. Also it won't be as bouncy.
Here is a rough sketch of what i have in mind:

I calculated the diameter while inflated to be around 127 cm!
The problem is i don't know what adhesive i can use, because ldpe has a low surface energy, and they won't bond that easily. Also i need an adhesive that is elastic or flexible, one that doesn't become rock hard after drying, like hot glue.
Or i can form a seam with a heating iron, but it's risky as it will deform the ldpe, form holes, and burn.
I heard some glues work on ldpe, but i am not sure which ones are good. So what methods are there to make two bags stick to eachother and be able to withstand high pressure?
So i thought maybe i can weld two of them together, cut one corner of the bag, stick a valve to it and make a GIANT ride roll.
Now why would i do this?
-my country does not have those 45"-60" balloons which i really want
-international delivery is expensive and takes a long time
-i'm not into animal shaped inflatables
-ldpe doesn't weaken after a couple inflations, so it's more reliable than balloons
What i don't like about this is that it won't shine or have that nice glossy balloon texture. Also it won't be as bouncy.
Here is a rough sketch of what i have in mind:

I calculated the diameter while inflated to be around 127 cm!
The problem is i don't know what adhesive i can use, because ldpe has a low surface energy, and they won't bond that easily. Also i need an adhesive that is elastic or flexible, one that doesn't become rock hard after drying, like hot glue.
Or i can form a seam with a heating iron, but it's risky as it will deform the ldpe, form holes, and burn.
I heard some glues work on ldpe, but i am not sure which ones are good. So what methods are there to make two bags stick to eachother and be able to withstand high pressure?
Comment