I had a 36 inch Intex tire tube with a tiny hole in the inner seam that I tried to repair with vinyl cement. Just ran a ribbon of the stuff along the seam. I did the whole seam, just because. I saw a you tube video of someone reinforcing seams this way so I figured if I managed to plug the hole I wanted the whole seam reinforced.
And while I had the cement out, I also did a 36 inch Intex clear-top tube with a slightly bigger hole in the inner seam. This one had a fatter pinch seam that would have required both sides done rather than one ribbon over the top, and I was tired of vinyl cement by this time, so I just repaired the hole.
And the results...
Overnight the clear-top tube lost a little bit of air, and the tire tube lost more than that. Failure?
I fully inflated the clear top tube and a 205 pound woman sat on it and it just popped. But...the part I had patched held! Tore right next to it, though. I figure I hadn't managed to plug the hole, but as reinforcement, the vinyl cement might have worked.
And so I resolved that the less successful tire tube would just pop. Fully inflated it and 205 pound woman sat on it...and it held! Sat opposite the hole, expecting it to pop, but it didn't. Overinflated the thing and she sat on it...and it held. Overinflated it quite a lot, and it still held.
Not sure where it's even still leaking. I think I might feel a tiny leak at the site of the hole repair, but it's so slight I can't tell if I'm imagining it. Perhaps it's leaking from somewhere else, too.
But the tire tube I consider a success, if I can just find the leak. I've given the whole seam another run, with special attention around the original leak. But maybe there's a pin hole leak somewhere not on the seam.
And while I had the cement out, I also did a 36 inch Intex clear-top tube with a slightly bigger hole in the inner seam. This one had a fatter pinch seam that would have required both sides done rather than one ribbon over the top, and I was tired of vinyl cement by this time, so I just repaired the hole.
And the results...
Overnight the clear-top tube lost a little bit of air, and the tire tube lost more than that. Failure?
I fully inflated the clear top tube and a 205 pound woman sat on it and it just popped. But...the part I had patched held! Tore right next to it, though. I figure I hadn't managed to plug the hole, but as reinforcement, the vinyl cement might have worked.
And so I resolved that the less successful tire tube would just pop. Fully inflated it and 205 pound woman sat on it...and it held! Sat opposite the hole, expecting it to pop, but it didn't. Overinflated the thing and she sat on it...and it held. Overinflated it quite a lot, and it still held.
Not sure where it's even still leaking. I think I might feel a tiny leak at the site of the hole repair, but it's so slight I can't tell if I'm imagining it. Perhaps it's leaking from somewhere else, too.
But the tire tube I consider a success, if I can just find the leak. I've given the whole seam another run, with special attention around the original leak. But maybe there's a pin hole leak somewhere not on the seam.
Comment