Love dolls vs. other inflatables

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • zycram
    Senior Member
    • Nov 2024
    • 408

    #16
    Originally posted by glovepopper
    I had a few cheap inflatable dolls, and I always tried to enhance their roundness by inflating them tightly, so they didn't last long with me. Their weak point, like other inflatables, is the seams on the negative curves. I repaired smaller tears, but if the tear was large, I threw it away. When the doll survived, I liked to open the valve when I came, which made my orgasm more intense.

    I intentionally destroyed one cheap doll (photos 3 and 4) by slowly inflating it with an aquarium pump. It took about 20 minutes, and I was lying naked on the doll the whole time. The doll burst in the perfect place - the crotch - so I felt a strong sudden blast of air on my crotch. It was an interesting experience and very exciting.
    I actually have a doll now but a slender one. Therefore, I have to inflate it pretty tightly for optimal arousal, to swell its waist and even the legs up a little bit. That's the difference between a little girl with big boobs and a real woman. Yes, roundness is key: anything round, tight and bouncy makes my cock swell up too. It is the best when it is the body of a charming woman but a pool toy or a doll too can be a big turn-on for me for the same reason.
    Last edited by zycram; 30-09-2025, 06:26.

    Comment

    • zycram
      Senior Member
      • Nov 2024
      • 408

      #17
      Originally posted by glovepopper
      I confirm that negative curves are the weakest points in dolls with more complex shapes than the flat missionary position. The doll from the photo below was probably an exception because it was cheap (~€5) but quite durable, perhaps because it was better welded. Sometimes, when the leak was small, I added air and fucked the doll harder so that it would finally burst with a bang when I reached orgasm.

      I have an idea how to reinforce a cheap doll... It will be time-consuming, but the reinforcements will not be visible from the outside. You need to cut the doll in a place that allows you to get to the seams from the inside - the back, for example. The cut should not be large, but sufficient to turn the doll inside out. Use long strips of vinyl (from another broken doll) and vinyl glue to reinforce all the critical seams from the inside. Once the glue on the reinforcements has dried, close the cut you made earlier, and you're done. It's easier said than done, but in my opinion, it can be done, you just have to be patient.
      What brand is this doll of?

      Comment

      Working...