Some heatstretch activity!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • MegaInflator
    Senior Member
    • Oct 2019
    • 132

    Some heatstretch activity!

    So I was looking for some "interesting" inflate to heatstretch (because bigger is better!) but I'm fairly limited on space and while mindlesly browsing I remembered inflatable fashion mannequins.

    I have tried these before, with ... varying ... degrees of success; they are built fairly sturdy, but they have A LOT of not very well finished seams which have a nasty habit of splitting/leaking.
    Not wanting to go through a huge reinforcing program I decided to buy some torso mannequins instead of full ones after the problem I had with those and the results were ... fun.

    The only thing I will recommend if you want to use these for anything: reinforce the waist seam with pvc glue first. It is typically the first to fail. Adding "branches" where seams attach to it is also recommended; don't have to be real long, about 5-6cm (2-2.5") i uually enough to prevent most problems. You can go full seam reinforce of course, but that's a lot of seam to cover.

    Process used:
    Aeration pump at 70 litres/minute, and a hot shower. I am VERY reluctant to use boiling water (as I've noted before) since I had some close scrapes with it before.
    Wait for it to inflate tight, spray with hot shower. If you want more localized stretch, hold that area under a running (hot) tap.

    First set of 3 photo's is about 30 minutes into the process. Advantage of the slow pump is I can keep it running throughout, don't have to stop. An unstretched mannequin is in both sets for comparison.

    Second set (of two, forgot there's a limit of 5 attachments, just did front/side) is another 15 minutes later, after the chest baffle inside decided to blow out. I did go too far and despite my reinforcing previously, a panel tore along a waist seam right next to the reinforcement and that wass trhe end of it.

    Lessons learned: more waist reinforcement (I'm thinking getting some pvc tape and gluing it over the seam all the way around for extra strength), less enthusiasm when you know you're at/near the limits.
    Fortunately these are fairly cheap so a failure isn't the end of the world, but it sucks to see a few hours of reinforcing/stretching get lost.
    Attached Files
  • MegaInflator
    Senior Member
    • Oct 2019
    • 132

    #2
    Alright, the boiling water demon wouldn't leave me be and I overcame my reluctance today.
    A few things I did different:

    * I preboiled water and put it in a thermos. Electricity and water cloe together are a big no-no for me.
    * I poured boiling water into a dish and pressed the area I wanted to stretch on the inflatable down into it, letting it slowly come up and stretch/relax upwards.
    * Once I had a decent start I started uing half cups of boiling water to specifically target areas

    Middle is "stock" outside are a pair of treated ones.
    Left side had all the reinforcements removed hence it looks bigger/rounder

    Stay safe, have fun
    Attached Files

    Comment

    Working...