So, while boiling some balloons this evening to see if it would work (what a weird sentence to write), I was wondering what is the most effective way to "heat treat" balloons?
At my disposal are:
Stovetop
Oven
3d printer bed (goes to ~100c)
Clothes dryer (But would rather not use)
Hair dryer
Are there other ways to make softer baloons without inflating them besides heat? Chemicals perhaps? (really doubt that I'd dabble into this based on forum advice but there might be some nontoxic ways, never know)
Someone else must have had these questions before and done the research. Please enlighten me!
At my disposal are:
Stovetop
Oven
3d printer bed (goes to ~100c)
Clothes dryer (But would rather not use)
Hair dryer
Are there other ways to make softer baloons without inflating them besides heat? Chemicals perhaps? (really doubt that I'd dabble into this based on forum advice but there might be some nontoxic ways, never know)
Someone else must have had these questions before and done the research. Please enlighten me!

Comment