I like building my own DIY inflators and have been working on something that feels cool enough to share.
Found a fan on Aliexpress (click for youtube vid showing it) and instantly decided it was going to be the core of my new balloon inflator.
The only obstacle so far are Will's (59balloons) fresh tripple dipped balloons. I need to stretch the neck while blasting full power to start inflation but after that the bulb inflates no problem!
Here is the prototype device itself... would not try to fly with it at this stage for sure. Q16 for scale.
Black shroud at the back is to avoid things being sucked in. It can be 20% shorter. Also have the narrowest attachment on it here so this is the longest it can be.
Linear potentiometer to control the speed controller. 4S lipo for the power (Calculated at 2 minute max power runtime).
Downside of this design is the requirement of a LiPo, not a fan of storing and charging those indoors personally.
It should draw 400-430w at full blast so this is about the only option.
inflator smaller.jpg
As its an ESP32 controlling this I should be able to program inflation routines for specific balloons, and even trigger them remotely using WiFi. Excited to use that for videoing some pump to pops in the future.
Found a fan on Aliexpress (click for youtube vid showing it) and instantly decided it was going to be the core of my new balloon inflator.
The only obstacle so far are Will's (59balloons) fresh tripple dipped balloons. I need to stretch the neck while blasting full power to start inflation but after that the bulb inflates no problem!
Here is the prototype device itself... would not try to fly with it at this stage for sure. Q16 for scale.
Black shroud at the back is to avoid things being sucked in. It can be 20% shorter. Also have the narrowest attachment on it here so this is the longest it can be.
Linear potentiometer to control the speed controller. 4S lipo for the power (Calculated at 2 minute max power runtime).
Downside of this design is the requirement of a LiPo, not a fan of storing and charging those indoors personally.
It should draw 400-430w at full blast so this is about the only option.
inflator smaller.jpg
As its an ESP32 controlling this I should be able to program inflation routines for specific balloons, and even trigger them remotely using WiFi. Excited to use that for videoing some pump to pops in the future.

Schematic might be fun to make yeah.
Comment