Looking for information

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Nopops4me
    Senior Member
    • Jun 2015
    • 976

    Looking for information

    I hope I'm posting this in the correct section. I've got a celebration coming up in 2024 and want to decorate with latex helium balloons. I want to have a go at inflating them myself. As I want them to be around and looking good for a day or so, i propose to use some Hi- float. Have seen video demonstrations of hi-float being used and I'm using Qualatex 11" balloons. Now my question is:- With the reliability of Qualatex these days, if one should burst will I get sticky shards flying all over the place or does hi-float dry quickly once inside the balloon??
  • lucid
    Senior Member
    • Sep 2016
    • 1174

    #2
    Yeah man you should be good to go unless one of your balloons pop a few minutes after you blow it up. After the 1st couple of minutes it dries. After that it looks almost like a thin layer of spiderwebs made of plastic on the inside. Keep in mind that if you're using clear or crystal colors this can be seen through the outside of the balloon as well after a prolonged period. Several days after inflation I mean. I actually think it looks cool but I'm sure non looners probably wouldn't agree.

    Comment

    • Nopops4me
      Senior Member
      • Jun 2015
      • 976

      #3
      Thanks lucid. I knew someone would know the answer to my question. As I was proposing to inject hi-float then straight on to the helium tank, it sounds as though I'd better be prepared for a splattering of sticky latex should one burst on the way to being blown up. No they are not clear or crystal balloons.

      Comment

      • UKPOPPER
        Senior Member
        • Feb 2023
        • 492

        #4
        Here's a tip - if you're concerned the balloons might burst on the tank then warm them between your hands or with warm water if you prefer and stretch them well before inflation. You could also pre-inflate with air before using the tank to weed out any faulty ones (and save helium). Doing that will mean they are less likely to pop on the tank and may get a better size and shape too. Bonus tip - printed balloons are less likely to pop on inflation than plain balloons because they have to be inflated for printing. 😊🎈
        Just one more puff...🎈

        Comment

        • Nopops4me
          Senior Member
          • Jun 2015
          • 976

          #5
          Cheers UKPOPPER. Thanks for the info. This forum is brilliant for getting answers to any questions you may have. Good to hear from you again UKPOPPER.

          Comment

          Working...