A sit/ride to pop question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • sonarloon
    Senior Member
    • Jun 2017
    • 121

    A sit/ride to pop question

    hello! It's been quite a while since I've logged in here to post anything! How's everyone doing?
    So a few weeks ago I was riding a cheap Chinese 24 balloon. The last of my PMU stash, from about 4 years ago.
    I wasn't quite straddling it more sitting and bouncing on it, getting rougher as I got curious with how much the balloon could take.
    I think it was 2 minutes later when the balloon popped under me and I fell pretty hard, ass first onto the tiled floor.

    What I'm wondering is for those of you who sit to pop, how do you soften the impact when you inevitably fall onto the floor?
    There was a thin throw rug on the floor that I thought would provide some padding, but I wouldn't have known that it even existed.
    I guess the next thing I could try is one of those seat padding things you buy for your car and just place a couple of those, stacked, on the floor.
    Or, do you suck it up and eventually just get used to the fall?

    I have some 36 inch ones that I wanna try some sit to pop with, but wow that's a really long way to fall!
    Take care, and see you all soon!
  • LoonerHoax
    Senior Member
    • May 2020
    • 521

    #2
    Re: A sit/ride to pop question

    After bruising and possibly breaking my tailbone from landing on my ass after a way overinflated 24" Belbal popped, I started putting down a couple layers of carpet padding when sitting on balloons. At my desk the padding is 3/4" think. In my other area the padding is at least an inch thick. In the other area, I did 2 layers of that 1" padding with some carpet over the top of it. I then proceeded to overinflate some large balloons to sit pop them. Landing on that padding after sit popping a necked out Q36 was absolutely painless.

    Comment

    • Guest

      #3
      Re: A sit/ride to pop question

      It's a matter preference but bouncing hard while straddling vs seated removes the risk of tailbone injuries, as your bent legs will absorb the impact before your behind hits the surface. I still do it only on the bed or a cushion, though.

      Comment

      • heaviest
        Senior Member
        • Jun 2018
        • 914

        #4
        Re: A sit/ride to pop question

        I have my own padding lol, but I also have a lot of weight to land on it, so it's probably a wash.

        I don't do butt-first popping, and definitely not chest-first, unless the thing compresses enough that I don't have far to fall, and I always do it on the carpet with padding. For beach balls bigger than 24 inches I'll put them on an island inflatable float or an air mattress.

        If you have the space to dedicate to the craft, look into getting a horse stall mat. Seriously. It's dense rubber. It stinks when it's new but the smell fades. You could probably cut it in half if its too large. Or get those interconnecting rubber tiles. Still use a rug over it, or even more padding than that. But it's definitely easier to fall onto than tile.

        Comment

        • TheMole
          Senior Member
          • Nov 2019
          • 302

          #5
          Re: A sit/ride to pop question

          I always ride in a straddling position to avoid this, like Merl said above, removes the risk of direct impact to the tailbone and shunts the impact off to your knees instead. I always use my bed when I just want to sit and pop them however.

          Comment

          • Faganite#47
            Member
            • Nov 2022
            • 39

            #6
            Re: A sit/ride to pop question

            I’ve never tried sit or riding to pop 36” balloons, I’ve always done 17” & 24” balloons I’ve always done it on my bed too

            Comment

            Working...