Bunch O Balloons : Re-engineered Version 1

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • zman21
    Senior Member
    • Jun 2022
    • 136

    #16
    Re: Bunch O Balloons : Re-engineered Version 1

    Hello friends,

    I would like to tell you about my first experience with this "bunch-o-balloon" pump. After a fairly long looner break, I'm more of a scaredy-cat now... that's why I "only" put 8 balloons on the pump for the first try and fled outside after I had switched on the pump.

    The tension was still huge and somehow I had the feeling that it was taking far too long... I just didn't hear a bang for a very long time. I was beginning to think that for some reason the pump wasn't popping the balloons, so I went back inside to stop the test. When I was 3 meters from the balloons it suddenly went BOOM BOOM BOOM... several loud bangs in quick succession and I quickly turned off the pump. There were only three balloons left - but they were incredibly tight and huge!!! A few seconds later BOOM again and there was only one last balloon left.

    I still managed to measure the diameter - it was 40.5cm, almost 16"!!! Shortly thereafter there was another bang and the last balloon had dissolved into tiny little pieces.

    I think I've passed the baptism of fire with this pump, even if the first try didn't quite go according to plan I can absolutely recommend this pump - it's super exciting and a lot of fun! And the balloons will be much bigger than expected!

    Greetings and have fun trying it out
    zman21

    Comment

    • stormbubble
      Senior Member
      • Nov 2017
      • 153

      #17
      Re: Bunch O Balloons : Re-engineered Version 1

      thanks for update, were these 12" to start? Need to figure out a good way like loonmaster did and reload with larger balloons!

      Comment

      • pinpopper
        Member
        • Mar 2019
        • 73

        #18
        Re: Bunch O Balloons : Re-engineered Version 1

        Love the nut and bolt style adaptor very nice loon master. Are these a 3D print and if so can you share the stl. If your into 3D printing this Hose connector is fully customisable via Customiser. I have used it to make adaptors for my inflator for bigger balloons.

        Comment

        Working...