⠀⠀⠀⠀⠀⠀⠀⠀
Rubber cement and balloons
Collapse
X
-
Tags: None
-
Re: Rubber cement and balloons
Well, as the handle name goes, I like to patch but I am only an amateur.
Only natural latex, the butyl rubber and the chloroprene rubbers I have not been able to glue successfully. The patch of rubber works better if it is thinner than the balloon to be patched. If the same thickness or thicker rubber is used for the patch it does not stretch and can cause breakage around the patch and irregular inflation shapes.
Surface preparation - for the toughest bonding I wash with tolulene - available as lacquer paint thinner at Home Depot. Wash both the patch and balloon area to be patched in a well ventilated area. I add some tolulene to a paper towel, then dispose of it outside in the garage because of the vapor fumes. For older non-shinny balloons and patches acetone maybe used but it is not as tight a bond. For the adhesive I use a heptane based rubber cement - Victor rubber cement. Brush on both surfaces and press together when still slightly wet but not dry. Wait at least 1 hour before testing.
I pre-stretch uninflated to see if the patch holds. If OK then I partially inflate to check.
Areas that fail to adhere - rewash with solvent and reglue with a bit of glue from a toothpick. The patch is like a new area on an old balloon so a couple of progressive inflations are need before full inflation, unless of course you want an early bang.Attached Files -
Re: Rubber cement and balloons
I noticed that the website Thirtythreerooms.com has some Frankenloons
so there are others patching balloons.Comment
Comment