Does anyone use unusual tools or instruments to burst their balloons? I like to torture them in different ways, such as pushing them against a sharp corner of a table or holding them close to my open fire until they burst from the heat.
Unusual busting tools
Collapse
X
-
GuestTags: None🥰 1👍 1 -
I put a bunch of push pins through a cardboard coaster and every once in awhile if I've got a bunch of balloons blown up that need bursting, I'll bring that thing out and have fun tossing balloons at it. It's exciting watching the last few inches as they drift downwards to either barely miss the sharpness awaiting them and roll slightly on the floor or land on a pin and burst sending rubber flying. -
Comment
-
Guest
The 'open fire' has always been a favourite of mine, ever since I was a lad of 8 and an uncle showed me how to make balloons suffer in front of the fire. He took 5 or 6 long balloons left over from the Christmas decorations, and interwove them into a tall metal fire-guard. Then he set the fire-guard in front of the fire and we sat and watched as the balloons expanded, squealed, cried and eventual burst one-by-one. We cheered as each balloon burst! It was so exciting watching them and knowing their time was limited.
I have an old piece of carpet strip (wood with a ton of tacks on it) a decent sized blowtorch, a lighter and cigarettes. I desperately want a weed whacker. And I really wished I was able to get my open fire working, hoarding balloons toward an open fire is a fantasy of mine!
Im iflating tons of mylars atm and using a heater to make them expand to pop. Super fun!☕ 4Comment
-
I sometimes like to wear a spiky belt, spiky bracelets, and spiky anklets while wrestling with or hugging balloons. Sometimes I'll wear high heels to tease them with too.Looning since 1989
To see my pictures of prints and blown up examples: Printed Balloons - Balloon and Inflatable Fetish Forum👍 1Comment
-
Guest
Sometimes I like to bounce overinflated balloons off my popcorn ceiling. Doesn't always burst them; you have to catch it in just the right spot, which creates suspence.👍 1Comment
-
I bought and use one of these. It's like a popping multi tool. Nice part is the only really sharp spike is the corkscrew, makes for some good suspense digging it in a bit without an immediate pop.
41Z8ADoRDlL.jpgComment
-
👍 1
Comment
-
Don't know how unusual it is but I use a remote controlled car with a needle attached to it. It's one of those that keep driving forward very slowly if you fix the controller with some tape. Like that the demise for my Balloon is slowly approaching. That's quite exciting really.Comment
-
We've recently discovered the fun of using a cake fondant shaping tool. Picture a toothbrush, but instead of having the bristley side, you have a large sphere, then on the handle side, you have a smaller sphere. You can really push this into latex balloons a good bit before they pop. Or you can just give them a quick jab and they pop immediately, most of the time.
It's also great to use on mylar balloons. I love watching my girlfriend press deep into one and drag it across the tight surface. Every once in a while it will catch, snagging the mylar and pulling on it and when it snaps free it makes that "thwomp" sound we all seem to love so much. If she presses and drags hard enough, it'll leave track marks. They look like raised welts that show where she used the tool on my balloons. It's probably become my new favorite tool.Comment
I remember as a kid being at an xmas party with overinflated balloons that we kept 'accidentally' batting towards the tree...
Comment