are thin spots on latex loons a death sentence?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Erthæl :3
    Junior Member
    • Sep 2026
    • 25

    are thin spots on latex loons a death sentence?

    description
  • LoonPopper
    Senior Member
    • Aug 2011
    • 772

    #2
    those are know as "Church Windows" they are were the latex is thin or didn't get thick enough, and yes it makes them more likely to pop.
    Blow, Baby, Blow...when will it pop nobody knows!

    Comment

    • balloonPatcher
      Senior Member
      • Jun 2020
      • 291

      #3
      I would say yes and no. Very round windows and a few inflations the window tends to hold. I have actually had a few older balloons have the window 'pop' and the balloon to start loosing air but not popping, giving me enough time to deflate it. However, if the window is irregular in shape and /or large it can cause the balloon to burst especially with multiple inflations.

      Comment

      • srob2
        Senior Member
        • Dec 2017
        • 552

        #4
        No, but a problem if you are afraid. Many of them will overinflate fine and get just as big as a regular balloon, but some will pop before rated size.

        Comment

        • Axle
          Senior Member
          • Jan 2022
          • 263

          #5
          alas that is the problem for a non-popper. the official answer is MAYBE. which is not our favourite.
          Curiosity killed the cattex.

          Comment

          • marvin19
            Member
            • May 2026
            • 51

            #6
            Hi,
            round spots with a sharp thick border are mostly harmless, especially near the balloon's top - which is good news actually. I even found some rare photo samples of me blowing a crystal-green Belbal 24" that has a visible spot within its top area. Hope you can see it (feel free to DM me for a larger image version).
            Thin-Spot-On-A-BB24-Part01.jpg Thin-Spot-On-A-BB24-Part02.jpg

            It was so funny when I saw that spot emerge through the balloon during blowing. And that spot did really grow... I didn't hesitate to blow this balloon further, because I was curious how far it would go. And as you can see, it got huge in the end and burst like it should do. I also had those round "church windows" with Tuftex 24" from time to time without much problems. Sometimes you also experience lighter and larger areas which look like someone had pressed his thumb on the balloon and perhaps you are afraid that this might be some thinner latex. With good quality balloons this is not the case but seems to be more a variation within the latex color. But: really thin and bubble-like areas are typical for overaged balloons, especially the Tuftex. Sometimes they get really huge anyway.

            Most of my balloons that burst too early showed no sign of defect before - which is actually some bad news for fearful blow-to-max looners. Or they are of poor latex quality, such that you can even feel that something is wrong, more than you see it, and right from the start.

            But because my experiences are somewhat limited to blow-to-burst activities, I cannot tell much about how they behave after multiple inflations and sitting or hugging or the like...

            Comment

            Working...