Miss that the thicker old school punch balls are no longer available. And wished that a really big one over 20" in dia. was produced. So I've been playing around with double stuffing big balloons to make them thicker and stronger for better punching. I took a rifco 80 cm balloon and stuffed it with an IN-JOOYA 24". Bounces pretty solid and very tight! Closer to being a punch ball. Only wish I could create a roll and tuck in neck instead of using rubber bands to secure it.
DIY Giant Punch Ball
Collapse
X
-
Tags: None👍 1
-
-
This is an update on the rifco/in-jooya balloon ball. I stuffed another IN-JOOYA balloon inside to make it three times thick! Balloon is tighter and makes a deep hollow sound similar to the old school punch balls. Very fun balloon!Attached FilesComment
-
I forgot to mention I added a rubber band handle from a scrapped punch balloon and glued it in place. So far the handle is still attached.Comment
-
Another update. Triple stuffed ball balloon holding up well taking a lot of abuse. Punched balloon so hard the rubber band eventually broke and it's a thick heavy duty rubber band. Ball bounces better than any punch ball going back many years ago. Super strong! I'm going to make some more of them.🥰 2Comment
-
Latest stuffed rifco 24" with IN-JOOYA 24". Single stuffed because I've learned one is really enough for bouncing. More than that the balloon gets heavier and harder. I may still use two sometimes. This one is just under 24". Feels like it could possibly take more but I punch these so I think this is big enough.🥰 2Comment
-
-
Having a ball with these! Latest one stuffed with a Gemar 80 cm. Inflated to 65 cm.🥰 2Comment
-
Experimenting with making the necks on stuffed balloons less cumbersome. I cut the lip off the neck of the outer balloon and wrapped rubber bands around both necks together to prevent air loss. Used a white IN-JOOYA 24" inside silver Rifco 80 cm. Inflated to 26". Punches good!Comment
-
Took top part of an old pioneer punch ball mated it to a Chinese IN-JOOYA 24" balloon. Now the neck can be rolled down and tucked inside like the old school punch balls. Except now the balloon is more flat on mated side due to the neck cut off to support the new part. I've been using these as bladders to make my giant punch balls. The result is no tying a knot or rubber bands to secure it.
Comment
-
-
Stuffed red rifco 24" with modified IN-JOOYAA fitted with Chinese punch balloon neck. I tried to use the heavier Pioneer ones but it made stuffing difficult. Current punch balls are more flexible to get inside the other balloon. The bulging neck from the IN-JOOYAA is now gone. I just rolled the neck down and put a rubber band over the outside neck to hold it in. Balloon is very round like a beach ball or old school punch ball.Comment
-
Made two IN-JOOYAA 24" balloons into punch balls! Glued top part of a Pioneer old school punch ball in place of the removed neck and added the bottom part with the knob for the rubber band. Balloon is shaped more like a pumpkin when inflated. But this one is not fully inflated. It is around 20". I'm being cautious for now before trying to get it to rated size. Unfortunately the white one suffered an air leak from a small hole in it. Punches good and the neck rolls down and tucks in securely.Comment
-
-
Put more air into the IN-JOOYAA "punch ball" to 22". Appears more evenly round now than before. Gonna see if it can can go to 24" later.Comment
Comment