Advice on aged/ older stored balloons?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • anon
    Member
    • Feb 2019
    • 31

    Advice on aged/ older stored balloons?

    I am a non popper. I've got a lot of Belbal 14's I purchased back in 2020 and 2022. What is the best way to know which ones I should inflate by inspecting the balloon prior to inflation?
    I usually like inflating them till just the necks start expanding.
    They've been kept in a dark, moisture free place and taken out once every few months to use then back to storing them.
  • SweetBouncer
    Senior Member
    • Mar 2020
    • 218

    #2
    Use a low pressure, constant volume pump, (aka fish tank air pump), and watch them as they grow, inspecting for any weakspots. Also, some factories use blacklights when testing balloons to see imperfections.

    Comment

    • NonPopFairy
      Gentle Looner
      • Feb 2025
      • 111

      #3
      Originally posted by anon
      I am a non popper. I've got a lot of Belbal 14's I purchased back in 2020 and 2022. What is the best way to know which ones I should inflate by inspecting the balloon prior to inflation?
      Be careful with any that stick to themselves or other balloons since that tends to show there will be some more fragile spots to the balloons, though only 3~5 years and well stored should be mostly free from that issue.

      Otherwise I'd follow sweetbounce's idea if you want to be careful.

      Comment

      • lukmanrewa
        Senior Member
        • Jun 2012
        • 491

        #4
        I'd the same worry, I always use a hand pump and see it within a couple of strokes whether there is any imperfection or in case it pops, it will go off softly. Electric pump tends to give more air and it may explode louder.

        Comment

        • bigloonfucker.cz
          Punk member
          • Nov 2023
          • 145

          #5
          Older balloons often become harder. This is caused by crystalization of latex. So it's better to heat up older balloons a bit beflore inflating. It's not necessary to use an oven. Hair dryer will do the job. Heat balloons from safe distance (0.5m/1') but heat them throughly (turn them over couple times) for about 10 minutes and then inflate balloons when they are still hot. They'll be not so fragile as without heating...
          The softer balloon the better. When not soft enough, I bake him untill success

          Comment

          Working...