Over rated balloon sizes?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • theloonerboy
    Member
    • Mar 2024
    • 285

    Over rated balloon sizes?

    I'm not sure if it's just me, or it seems like the rated diameter of balloons is less than what is advertised? For example, a Belbal14 will be fully inflated and feel tight at 12" and the neck will start coming out beyond this. I haven't gone past 12 1/2" - 13" at the very max, but I assume that to reach the 14" rated size, the balloon must be close to popping.

    Seems like I'm having the same results with Qualatex 11". At 10" diameter, they are very tight. Too bad I don't have the nerve to neck them fully! To measure the diameter, I put the widest part of the balloon between the door of the closet and the frame. I then close the door until the balloon is just touching and then measure the gap. It's accurate probably within 1/4"-1/2" inch.

    Anyone here has tried such a thing or would like to try it and share their results?
  • MrMars
    Member
    • Aug 2024
    • 54

    #2
    Most balloons are made for decoration... their nominal size is so that decorators know when they will be as round as possible.
    Some balloons have the correct shape for decoration smaller than the nominal, but most balloons achieve this point of decoration in the nominal.
    With me, the only balloons that burst before their nominal size were those that had a manufacturing defect.
    From my experience as a non-overinflation lover, balloons burst after 25% of their nominal capacity.

    Comment

    • Nopops4me
      Senior Member
      • Jun 2015
      • 976

      #3
      I'm not an authority on this subject, but my two pennyworth is:- Probably anyone who blows up their balloons for decorations for an event stops blowing when it looks right and never measures each one for size. It's only us lot that sometimes measures the diameter to see if they have reached the manufacturers rated size printed on the packet. A good balloon without any flaws or holes should reach rated size , no problem. For non poppers and phobics, it is concerning that the balloon gets tight and neck appears at around 12" of a 14" rated balloon. Yes you can stop inflating at 12" and your balloon looks decent. But if you keep going to 14" it will take it. In fact it'll more than likely go even bigger, but then you risk it bursting. Balloons are generally made to be burst and manufacturers make balloons to go to rated and tighter to give a louder BANG when they burst, to give poppers a bigger thrill.
      That's my two pennyworth. Enjoy your balloons however big you like to inflate them to.

      Comment

      • Scooter
        風船天才
        • May 2022
        • 497

        #4
        Originally posted by Nopops4me
        Balloons are generally made to be burst and manufacturers make balloons to go to rated and tighter to give a louder BANG when they burst, to give poppers a bigger thrill.
        They DO make them to be burst at some point and do try to make them tighter, but it's actually because if the balloon is too soft/stretchy and falls on the ground someone might trip and fall over when they step on it. The safest thing for the balloon to do is pop and give way rather than roll out from underneath someone.

        Comment

        • lukmanrewa
          Senior Member
          • Jun 2012
          • 491

          #5
          Depends on the brand though, some of them underrate their size as well.

          Comment

          • AlterPlatzer
            Senior Member
            • Jun 2024
            • 1528

            #6
            Some brands of balloons need a bit of pre-stretching to inflate to their rated size.

            I have heard that some brands measure the rated size from the nozzle to the drip and not the width.
            It's OK to love balloons.
            There are as many differences in preferences as there colors of balloons. Accentuate what makes us the same and not what sets us apart.

            Comment

            • theloonerboy
              Member
              • Mar 2024
              • 285

              #7
              That makes sense.

              Comment

              • Thinskinned
                Look Out!
                • Jul 2024
                • 247

                #8
                with the qualatex, try inflating fully, then deflating, then reinflate a second time. You'll probably find that it goes right on past 11" without looking or feeling over-full.

                Comment

                Working...