How to fix a small leak

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Inflatable18
    Member
    • Jul 2023
    • 32

    How to fix a small leak

    I recently bought a transparent horse from horseplay toys, and have known there was a small leak since I got it, however it was small enough that I couldn’t find it. This has now been confirmed, as when I went to inflate it today looking for it again, it looks like it has grown from a small leak into a larger leak. It is about 3-4mm long along the belly seam. I tried to capture it on camera, but it is very hard to see still:

    image.jpg

    I can’t find much on repairing this type of hole, the only things I find are for large seam splits where repairing requires putting a strip of vinyl along the inside of the seam. This seems not possible to do in this case, but a patch on the outside akso seems difficult due to the frill of the seam.

    Any advice would be much appreciated.
  • Bass Boll
    Senior Member
    • Jun 2023
    • 211

    #2
    Re: How to fix a small leak

    Dear I18, I don't know why nobody answered your question earlier. Don't feel neglected. Here is how I would tackle your case:

    I would get me a pair of nail scissors, a small patch of soft PVC film, and adequate glue for soft PVC. Ideally both the patch and the glue were transparent.

    First, I would carefully cut off most of the seam ridge, or frill as you call it, next to the hole using the nail scissors. I assume the inflatable to be deflated, otherwise now is the time to fully deflate it while keeping the vinyl around the hole as plain as possible and ideally without wrinkles. Then I would clean the hole area from traces of fatty acids with a tissue dipped in pure ethanol or alcohol-based disinfectant. No cigarettes or lighters allowed! Afterwards, I would rinse the tissue with water for additional fire safety.

    For the next step it is also advantageous to open the windows: Glueing the hole, perhaps 1mm thick, and the glue blob should clearly expand over the trimmed seam. Also apply a thin glue layer to one side of the patch which should be cut into a round shape (3 cm / 1in in diameter should be enough). Usually the glue has to sit and dry for an hour before the patch can be applied. Then you press it on the hole, rubbing from the center of the patch to the edges, also using finger pressure, the more the better. Now wait for at least 24 hours before you re-inflate. Then the little leak should be history. Have fun!

    Comment

    • grizzleylooner
      Senior Member
      • Aug 2023
      • 158

      #3
      Re: How to fix a small leak

      Agree with above, just make sure you get glue that's made for soft PVC. The plumbing stuff doesn't work very well.
      HH-66 is the one I use, drying times are faster, about a minute to dry before applying patch and can usually inflate and ride in a couple of hours unless it's a massive repair. I'm a big bloke and like a good ride so repairs are kind of inevitable!

      Comment

      Working...