Moding inflatable valves

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • wildheart
    Senior Member
    • Apr 2015
    • 872

    Moding inflatable valves

    Dose any one have any experience in modifying inflatable valves? I want to remove the check valve so I can inflate it faster and easier. Might even replace the valve with something else.
    How big will it go? Only one way to find out...
    My website: loonerstories.weebly.com
  • OverTheTop
    Senior Member
    • Dec 2013
    • 749

    #2
    Re: Moding inflatable valves

    Originally posted by wildheart
    Dose any one have any experience in modifying inflatable valves? I want to remove the check valve so I can inflate it faster and easier. Might even replace the valve with something else.
    All you would have to do is poke a hole through the center part of the valve and that should accomplish what you want.

    As far as modifying the valve/switching it out, it would be hard to do it 1) without damaging the inflatable and 2) in a way that won't significantly weaken the seams around the valve, so I'd imagine it hasn't been done reliably before.

    Comment

    • SoniaStrummFan217
      Junior Member
      • May 2012
      • 16

      #3
      Re: Moding inflatable valves

      I found this video tutorial on YouTube that may help. http://youtu.be/4Ixw0t7wYcA
      Every book is a Tardis: Innocuous on the outside, bigger on the inside, and able to transport you through time and space.

      Comment

      • Vicci
        Blown to bits
        • Oct 2009
        • 816

        #4
        Re: Moding inflatable valves

        I tend to grab the little flap through the vinyl, and pull/twist it off. It ends up stuck inside the inflatable rattling around, but that doesn't bother me.
        Vicci x

        Comment

        • craggy2012
          Senior Member
          • Jan 2012
          • 842

          #5
          Re: Moding inflatable valves

          I normally take the safety flap out of the nozzle to speed up inflating and deflating afterwards on my inflates....

          I've got a small pair of curved tipped locking forceps from a hardware store to grab n pull the flap up through the valve with, then you can grab the flap with the forceps and lock them tightly- give it a few slow twists around and the flap should tear free without damaging the nozzle. Just be careful manipulating the flap to start with... It's probably best to push it upwards into the nozzle with your fingers through the vinyl first if uninflated as those forceps can easily puncture a hole through the vinyl if they slip.

          Comment

          Working...