Questions for the technical minded: pvc vs rubber

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Guest

    Questions for the technical minded: pvc vs rubber

    Hop balls have always been made of various forms of PVC. Never has there been one commercially made of any formulation of actual rubber. But if one were to be designed...say a 24 inch all rubber hopper...

    1. How would it be assembled? Could it be molded like PVC to be thick enough for bouncing? Or pieces/panels welded together?

    2. How thick would it have to be? And is there a stiffer formulation of rubber? Else you would end up with pretty much a thick weather balloon, strong but still too flabby to bounce around on.

    3. It would not be as durable for decades as PVC, which can still behave like new over 50 years later. What would help with durability while keeping the weight of the thing usable?

    4. Assuming it got made, would you expect it to feel and perform differently from PVC?
    Last edited by Guest; 13-11-2022, 12:13.
  • craggy2012
    Senior Member
    • Jan 2012
    • 842

    #2
    Re: Questions for the technical minded: pvc vs rubber

    I believe you could theoretically roto mould a ball from latex rubber- infact most play balls are made that way. Roto moulding is a hollow two part mould (two hemispheres) that a given quantity of liquid plastic or whatever synthetic material is used is poured into, then the mould is span on a sort of centrifuge allowing the material to completely coat the inside of the mould. Once cooled the halves are parted and your left with a one piece ball. Depending on the formulation they can be semi rigid like play balls, or softer like exercise balls so you can easily inflate them to size at home. Beach balls on the other hand are fabricated from six or twelve identical sheets of PVC (or foils as called in the trade) that are then welded edge to edge in a set sequence which is then turned inside out to complete the last external closing seam so you end up with the ball- then two round poles (one complete with pinch valve) are further welded to the ball to complete the item.

    As for rigidity exercise balls are sturdiest, then PVC vinyl with pure latex rubber being the weakest.

    As for longevity, well that depends on formulation of the material and how you store it there after and ultimately howto treat them. I’ve got some inflatables that are now approaching 35 years old since I purchased them that are still as good as new, but the more you use them at some point they’re going to fail. That’s inevitable!

    Comment

    • balloonPatcher
      Senior Member
      • Jun 2020
      • 291

      #3
      Re: Questions for the technical minded: pvc vs rubber

      I think that it would be doable with a technique called slip casting.
      It is the same sort of technique that they would use to create latex masks.
      A two piece mold from ultracal 30 at 24" diameter would be quite heavy so I would start with a mini version first to get it to work first. I have a #5 bladder for a punching bag that weights 130 gm and is very tough. I have inflated it once and got to a psi of 50lbs with no stretch at all. As far as longevity, I would suggest chlorination. I have some latex dolls from the mid 90's that are have not deteriorated and are probably chlorinated.

      Just my two cents.

      Comment

      • Guest

        #4
        Re: Questions for the technical minded: pvc vs rubber

        If I could afford it, I'd approach a rubber molding company to do a prototype. Handles would be needed and probably best if integrated, not glued on. Sticks would have to be the simplest.

        Comment

        Working...