the math of 800 pounds on a beach ball

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • heaviest
    Senior Member
    • Jun 2018
    • 914

    the math of 800 pounds on a beach ball

    Did you know that the size of the contact patch of an inflatable against the floor, in square inches, times the pressure in PSI, equals the weight on the inflatable? I learned this from someone who said you could calculate the weight of a truck this way!

    You generally don't know the pressure of an inflatable, and the area of the contact patch gets complicated with complex inflatables, so let's do some math with a 24 inch beach ball.

    I have measured pressure in inflatables, but not beach balls, specifically, but let's assume they are similar. The most I was able to blow was in the neighborhood of 1.9 psi, if I recall. Let's say we're targeting 1.8 psi with weight alone and not overinflation.

    As an inflatable stretches, the pressure decreases. As the vinyl stretches, it becomes weaker. You get a runaway stretch if the pressure never decreases enough to stop stretching the inflatable. If the decreasing pressure falls below the pressure needed to stretch the vinyl further, it stops stretching.

    What happens when an 825 pound woman sits on a well-made 24 inch beach ball? For some of us, this is a real scenario! A woman that size cannot get all her weight on a beach ball on the floor. She is so much bigger than the ball that some of her touches the floor around it. Even if she manages to keep her butt fully off the floor, her thighs contact the floor. And some of her weight is on her calves. I could potentially measure how much weight is actually on the ball, but I haven't. So let's assume it's about 700 pounds. That probably isn't actually achievable, but I want to overestimate rather than underestimate.

    The outside circumference of a fully inflated 24 inch beach ball is about 25 inches. I assure you that when you sit 700 pounds on a beach ball, the ball stretches enough tat the contact patch gets to be at least as big as the original outer circumference of the ball. We'll calculate where it goes from there.

    The area of a 50-inch circumference circle is about 200 square inches. The pressure would be 700 pounds over 200 square inches, or 3.5 PSI. That sucker is going to keep stretching until either it pops or the pressure reduces to something like 1.8 PSI. In fact it will probably have stretched larger than that before she has loaded all her weight on the ball, so it will never hit that pressure.

    Let's calculate for 1.8 PSI. 700 pounds over 1.8 PSI would be about 390 square inches. That would be a contact patch about 22 1/4 inches across, with a circumference of 70 inches. That ball is pretty squashed, and the outer circumference isn't a lot bigger than 70 inches. Probably about 85 inches. 85 over 50, the original size, is 1.7. A 70% stretch.

    Will a beach ball stretched 70% with 700 pounds on it be in a runaway stretch and continue to stretch until it shreds a panel? My experience says yes. Even when the actual load on the ball is probably under 700 pounds, and the ball is on another inflatable, which increases the contact patch somewhat.

    If you calculate the size of the contact patch for a swim ring (remember to subtract the inner area), you'll see that a 36 inch swim ring (32 inches inflated), even not stretched very much, does not achieve anything close to 1.8 psi with 700 pounds on it. Yes, a 36 inch swim ring will generally hold an 825 pound woman, for a while, if she spreads her weight over the whole inflatable. It will keep stretching, though, until it leaks or pops the inner seam. Swim rings aren't nearly as sturdy as beach balls. It takes less PSI to pop them.

    I've had swim rings survive thirty minutes with 800 pounds on them!
  • heaviest
    Senior Member
    • Jun 2018
    • 914

    #2
    I won't link it because people may find it ick, but if you search "mary boberry playing with her ball" on reddit, you'll find a video of a 600 pound woman sitting on a 42 inch beach ball. Let's calculate a contact patch!

    Assuming lower pressure, 1.3 psi, because bigger balls will take less pressure, and she doesn't have it inflated as tightly as I would, and about 500 pounds on the ball, the contact patch would be about 24 1/4 inches across. Smaller than the original diameter of the ball, though the outer diameter clearly gets bigger as she sits on it. This ball is not nearly as squashed as the 24 incher with 700 pounds on it.

    I've had more than 500 pounds on that Intex ball. It's scary because it is farther off the ground than a 24. That 825 pound woman, about 100 pounds ago, sat with more of her weight on the ball than Mary did, for longer, and the ball was more fully inflated. The 42 inch Intex is a tough ball.

    Comment

    Working...