inquiry about heat stretching methods + merging air chambers

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Eugenejohn123
    Junior Member
    • May 2025
    • 7

    inquiry about heat stretching methods + merging air chambers

    Hey everyone! I really appreciate all the support and replies from the community on my last post!

    I just picked up a Bestway whale and was thinking about trying to heat stretch it a bit. I really enjoy seeing inflatables expand in size (without popping, of course!). In the past, I’ve used the sun or a clothing steamer to stretch some of my other inflatables, but I haven’t had much luck getting them to stretch too much or keep the size over time. I’d love to hear if anyone has any tips or experience with heat stretching.

    Also, has anyone tried merging air chambers to get more air into the main one? I’m curious if that could help with increasing the overall size or if it might make the toy too fragile.

    Any replies are appreciated. Thanks!
  • Seasidelad
    Senior Member
    • Sep 2018
    • 303

    #2
    I use either very hot water poured over carefully then add more air or steam fill I am going to try this on my Bestway Nemo Fish. The only time I have merged chambers not always sucessfully is by popping the baffles like on Unicorns Flamingos those kind of toys so the go round like a balloon. I tried this on a turtle but damaged it and couldn't repair I thought it could be mounded like a tortoise. When I get the time I going to try it on my old Intex crocadile.

    Comment

    • Clockman
      Junior Member
      • Mar 2025
      • 23

      #3
      Heath Dragon on youtube has many good videos on the subject. I recommend using a clothing steamer, as boiling water can overheat one spot on the toy and pop it, flinging the hot water at you, causing bad burns. You don't want to explain that at the hospital. As for maintaining the size, it is partially permanent. When you deflate the toy, the vinyl will "relax" a bit, and return back to the shape it originally was at. Not all the way, but a bit. PVC has memory. Good luck.

      Comment

      • Markus_Looner
        Member
        • Apr 2024
        • 59

        #4
        I've also been very curious about merging the air chambers. Is it as simple as taking a thin pen knife and putting it through the valve, or is it a matter of over inflation to get the baffles to release?

        Comment

        • MegaInflator
          Senior Member
          • Oct 2019
          • 132

          #5
          Originally posted by Markus_Looner
          I've also been very curious about merging the air chambers. Is it as simple as taking a thin pen knife and putting it through the valve, or is it a matter of over inflation to get the baffles to release?
          NEVER try to force-merge by overinflation alone. You likely will burst/pop before.

          Creating a controlled failure by weakening/breaking interior baffles (and yes, you can do this with a scalpel/pen knife or small scissors) gives you a much better chance of a good chamber merge.
          Notice: you can still get unlucky and split an exterior seam or get a rip.

          The ideal way to chamber merge is to break/compromise the interior baffle and manually pull it apart with jut a little bit of air inside -- trying to do it by inflating is faster (by a lot) but you keep that risk of a fail/burst.

          Comment

          Working...