ATBC question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • MegaInflator
    Senior Member
    • Oct 2019
    • 132

    ATBC question

    Got my hands on a few 80ml bottles of the stuff (Cernit Magic Mix) and wondering how much of it I should use.

    Target inflatable is a single person airbed (185x76x22cm) .. suggestions ?
  • OverTheTop
    Senior Member
    • Dec 2013
    • 749

    #2
    My rule of thumb is that 30mL per kilogram of vinyl is a safe maximum to start with that will have noticeable effects, without overdoing it. If you're unsure, it's good to err on the side of caution because it's easy to add more later, but you can't really remove it.

    Comment

    • MegaInflator
      Senior Member
      • Oct 2019
      • 132

      #3
      Thank you!

      EDIT:

      I poured in ~40ml put a bit of air into it and tried to shake/spread it around. It seem to have mostly gone down one side (idm if it ends up a bit uneven) ... add more now or just let it absorb first then add more ?
      Inflatable was completely NIB before, never inflated, always stored.
      Last edited by MegaInflator; 09-05-2025, 10:03.

      Comment

      • MegaInflator
        Senior Member
        • Oct 2019
        • 132

        #4
        Update: It successfully failed.

        I had left the airbed inflated overnight (full, not tight) and when I chercked on it this morning, a couple of the inrernal pillars looked like they failed.
        At first I wondered if they had become stretchy enough from the ATBC to lose functionality, so I put a bit of air in to see what happened and was instantly greeted by confirmation they HAD failed since about 3-4 more pillars failed in rapid machinegun fashion!
        Going to need to rethink now, but I'll have some fun with this one in the meantime ....

        Comment

        • MegaInflator
          Senior Member
          • Oct 2019
          • 132

          #5
          Update: game over.

          Figured I'd ride it while sequentially popping all the pillars ... and then one of them ripped out out the envelope leaving a very large, very neat, very circular hole causing immediate loss of pressure.

          Comment

          Working...