Thanks for the kind words.
1. I preinflated each finger twice before inflating the whole glove. The "magic trick" after inflation was, putting a wide tube with adapter to a small hose on each finger and sucking all air out of it to stretch the fingers. With some gloves, the fingers stay even more inflated. I really like it, when the fingers look like that, hence the effort ^^
2. Unfortunately none of these tests sticked together, when being inflated. It is airtight, but tears apart when stretched too much, what always happens, when being inflated. Most latex gloves have some coating instead of powder, so rubber cement does not work. Balloons can be glued without any problems with the same method. There are some gloves that can be glued, but i still have to find out.
Maybe it helps to use a piece of regular latex for connecting the gloves like a bridge (from a balloon or sheet latex).
As shown in the picture below, a piece of latex can make a very good bond with the same glove, but the gloves don't like being glued together directly.
grafik.png
The method below could work, but i did a poor job glueing these together, so it tore apart.
I've gotta try this again:
grafik.png
1. I preinflated each finger twice before inflating the whole glove. The "magic trick" after inflation was, putting a wide tube with adapter to a small hose on each finger and sucking all air out of it to stretch the fingers. With some gloves, the fingers stay even more inflated. I really like it, when the fingers look like that, hence the effort ^^
2. Unfortunately none of these tests sticked together, when being inflated. It is airtight, but tears apart when stretched too much, what always happens, when being inflated. Most latex gloves have some coating instead of powder, so rubber cement does not work. Balloons can be glued without any problems with the same method. There are some gloves that can be glued, but i still have to find out.
Maybe it helps to use a piece of regular latex for connecting the gloves like a bridge (from a balloon or sheet latex).
As shown in the picture below, a piece of latex can make a very good bond with the same glove, but the gloves don't like being glued together directly.
grafik.png
The method below could work, but i did a poor job glueing these together, so it tore apart.
I've gotta try this again:
grafik.png
)
Comment