Using a hairdryer for stretching balloons

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • AlexinoMaxx
    Junior Member
    • Aug 2021
    • 14

    Using a hairdryer for stretching balloons

    I just found out about blowing hot air on a used balloon to repair the wrinkles. And i can say it's a game changer. Big balloons seem newer. But i was surprised they inflate even bigger, and i think they are even stronger than before!

    I normally inflate them fully, or until it feels slightly harder to push my hand into them. But after i heated a balloon (45", don't know the brand) with a hairdryer it made this threshold appear when it was much much bigger. And it was also stronger! I could bounce on it as hard as i could, wouldn't pop!

    Without hairdryer
    With hairdryer

    But something's fishy. It's too good to be true. Unheated balloons would normally overinflate to this point, so what makes it? How is it molecularly possible? The latex smell is also stronger, closer to the smell of burning rubber. Is it more likely for a soft heatstreched balloon to pop than a firm normal one the same size?
    Bounce on a trampoline and no one bats an eye.
    Bounce on a balloon and society loses their mind.
  • UKPOPPER
    Senior Member
    • Feb 2023
    • 492

    #2
    Re: Using a hairdryer for stretching balloons

    I'm not that brilliant at physics but I think latex is made up of long protein chains and when you stretch it you are pulling these chains apart but the bonds between them make them retract back into place when you let go. If you warm the latex you are adding energy, which makes it easier to slide the chains apart - it feels softer. You can stretch it further without a catastrophic break in the bonds, i.e. less taught/brittle and less likely to pop unexpectedly. Latex is amazing, that's all. 😁
    Just one more puff...🎈

    Comment

    • Whale Rider
      Senior Member
      • Nov 2022
      • 531

      #3
      Re: Using a hairdryer for stretching balloons

      Originally posted by UKPOPPER
      I'm not that brilliant at physics but I think latex is made up of long protein chains and when you stretch it you are pulling these chains apart but the bonds between them make them retract back into place when you let go. If you warm the latex you are adding energy, which makes it easier to slide the chains apart - it feels softer. You can stretch it further without a catastrophic break in the bonds, i.e. less taught/brittle and less likely to pop unexpectedly. Latex is amazing, that's all. 😁
      long chains yes but not proteins its basically isopren units cross linked with sulfur bridges... make it hot and you make aligning the chains towards the tensile load easier.. thats also why stretching works...

      Comment

      • Whale Rider
        Senior Member
        • Nov 2022
        • 531

        #4
        Re: Using a hairdryer for stretching balloons

        Originally posted by Blown2Bits
        Inflating a balloon damages the bonds inside the latex, making the latex softer and stretchier. so eventually it will pop early if you do it too often. heat is doing similar things to the latex, so it just accelerates the aging process.
        keeping it inflated increases the area onto which oxygen can do its business of breaking the isopren units... and break the chains...

        Comment

        Working...