I don't really see this talked about much but what are your experiences with using heat to shrink balloons? I recently tried this and it did bring back some firmness to it. But what do you think? Does it make it stronger or weaker?
Heat shrinking
Collapse
X
-
Re: Heat shrinking
I use a hair dryer to heat shrink my balloons. Using heat to shrink a balloon close to it's original, uninflated size actually weakens the balloon. It will, however, allow the balloon to be inflated larger than the first time. And each time you heat shrink the uninflated balloon, the balloon will get even larger than the previous time. The draw back is that the latex bonds are being weakened further, each time you use heat to shrink it, so it will eventually become really thin, and pop easily. It will develop thin spots and failure of the balloon will happen shortly after. -
Re: Heat shrinking
i was always under the impression that higher temperatures will weaken/soften the latex like baking but not too hot (around body heat level) would actually extend the life of the thing.
i've been doing this for years now and some of my balloons are well used but still in one piece even getting towards a decade old.Curiosity killed the cattex.Comment
-
Re: Heat shrinking
Depends on the balloon and the amount of heat. I have had the experience of Q24's and other quality balloons being stronger on the third or fourth inflation with shrinking the balloon back down with a hair dryer on low heat. I always felt that if the balloon just sits after inflation and is touched in certain areas, they inflate funky the next time.Comment
Comment