Baking balloons with amazing results!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Boom&Bust
    Senior Member
    • Jan 2021
    • 111

    Baking balloons with amazing results!

    At last I've managed to find a way of baking balloons that works.

    I put 12 inch Gemar balloons that I got from Tesco inbetween two pieces of foil on a baking tray, pressed and bent the edges of the two sheets of foil together to get some sort of seal (the seal doesn't have to be perfect), then put them onto the second shelf in the oven, already preheated, at 140c no fan, for 18 minutes.

    Once baked I will blow up the balloon and stretch the neck a little, then let it deflate and inflate only the neck a few times, then inflate the balloon again, they get quite huge and they're really soft and delicate, and when they pop they pop about half as loud as how loud they pop when not baked. They're pretty much the same as these balloons in this video. https://www.youtube.com/watch?v=DpTSKbvsqcI

    For years I've wanted balloons just like those in the video, but could never find any, now I can make my own! In real life they look a lot more impressive than how they look in the photos.

    On left is an unbaked one, and on the right is a baked one.

    SAM_9333.JPG

    In this pic I had baked the yellow balloon on the right just like how I described above, except I had put it on the first shelf instead of the second in the oven, this made it get even bigger and softer, but when baking them this way some of the balloons (probably 4 out of every 10) can get a bit defective and pop when inflating.

    SAM_9335.JPG

    Since ovens are different, you may need to tinker a little with the instructions I gave, like maybe not preheating the oven, or having the foil sheets not on a baking tray (which will make the chances of defects less likely, but the balloons wont get as big and soft), etc.

    I will be receiving some 17 inch and 24 inch Tufftex balloons, I can't wait to try baking those, since they are a different brand the baking may not go as well, but hopefully it does.
    Last edited by Boom&Bust; 05-03-2022, 20:45.
  • Guest

    #2
    Re: Baking balloons with amazing results!

    Wow, simply beautiful. They look so big and tight.

    It is a brave act to get the necks so full. Balloons with swelled up necks seemed to be the norm growing up in Australia in the 80s and 90s but nowadays it would be rare to see a necked balloon anywhere.

    Comment

    • srob2
      Senior Member
      • Dec 2017
      • 552

      #3
      Re: Baking balloons with amazing results!

      I'd love those, never had any luck baking. Did you mean 140F? I've turned balloons into a smelly puddle trying this at lower temperatures.

      Comment

      • Boom&Bust
        Senior Member
        • Jan 2021
        • 111

        #4
        Re: Baking balloons with amazing results!

        I mean 140 centigrade/celsius.
        Last edited by Boom&Bust; 07-03-2022, 08:35.

        Comment

        • Guest

          #5
          Re: Baking balloons with amazing results!

          So, baked loons would not be as good for bouncing, if you like to bounce as long as possible without an immediate pop?

          Comment

          • Boom&Bust
            Senior Member
            • Jan 2021
            • 111

            #6
            Re: Baking balloons with amazing results!

            Originally posted by Merl
            So, baked loons would not be as good for bouncing, if you like to bounce as long as possible without an immediate pop?
            That's true, unless you did some light bouncing.

            I enjoyed bouncing really hard on the unbaked ones, I gave them and myself a good workout and it took ages for them to pop. There's no way the baked ones would be able to stand up to that.

            Comment

            • SirSquishy
              Senior Member
              • Mar 2020
              • 233

              #7
              Re: Baking balloons with amazing results!

              Originally posted by Boom&Bust



              I will be receiving some 17 inch and 24 inch Tufftex balloons, I can't wait to try baking those, since they are a different brand the baking may not go as well, but hopefully it does.
              I will be baking some balloons myself soon, thanks for the instructions. Am curious to know how baking those 17 and 24 inch ones went.

              Comment

              • Danniballoon
                Senior Member
                • Mar 2018
                • 785

                #8
                Re: Baking balloons with amazing results!

                Got to try it. I always wanted some like the ones in the Nathalie video. I have some 27" Gemar that are so hard and they don't stretch even after half a dozen inflation/deflations. Making them softer, would be awesome.

                Comment

                • bigloonfucker.cz
                  Punk member
                  • Nov 2023
                  • 145

                  #9
                  In past I couldn't figure out how to make the balloons softer for a long time. hard balloons don't excite me. now I bake them at 160°c until the heating spiral turns off for the first time, but with a fan. the balloons can be up to 2 times the size, but then there is a risk of them bursting, but that softness.... everyone has to experiment with their own oven to find out what the right temperature is. Better start with cheaper balloons...
                  ​
                  The softer balloon the better. When not soft enough, I bake him untill success

                  Comment

                  • srob2
                    Senior Member
                    • Dec 2017
                    • 552

                    #10
                    I've messed with this a lot, and never managed anything other than making a mess. Either the balloons melt or come out unchanged.

                    Comment

                    • Unicks
                      Senior Member
                      • Nov 2020
                      • 103

                      #11
                      Yeah, baking balloons can be a tricky prospect.. A convection oven is almost essential to provide even heating, without that you're just flying blind. I have a gas convection oven and the humidity (possibly the CO2 as well) from the combustion has an effect all it's own. With just regular baking, the bottom side of the balloon was always less affected.. so I tried a silicone mat and found better results. Ultimately the convection gas oven has worked the best, even a pile of old stiff SA24" balloons that I was going to throw out came back using the bake method. So there is merit to baking, how much and the specifics vary from brand to brand.

                      There is no gain in strength, only size.. I'm not a bouncer per se.. but you can expect not having those snappy pops you get from tight balloons. For instance, Cattex has a really forgiving latex compound and you can cook a figurine or a long neck to almost double in rated size and still ride it.. and I'm over 100k.

                      I just tried baking a couple of Roomtex balloons as well, seems their giants like the RX50L and RX36L can benefit too.. these are already massive balloons with durability in mind, but I baked the RX36L first and it gets stupidly huge! The neck is like an overinflated gl700. I tried to pop it by wrestling with it on the floor and it could hold your weight without issue, it was just the expansion factor.. possibly try to put it on the pump next time and see just how big they will get.

                      Good luck!

                      U

                      Comment

                      • Sit2Pop
                        "Laykir The Loonedge"
                        • Oct 2023
                        • 100

                        #12
                        I'm kinda curious to try this out with some of my balloons, especially old and worn out balloons. This could be a good way to extend the life of balloons that would have otherwise been popped or otherwise worn out! I'm curious to see how much bigger it can make brand new balloons get to as well. Definitely on my agenda to try this out in the near future.

                        Comment

                        • Alan
                          Senior Member
                          • Dec 2014
                          • 251

                          #13
                          Originally posted by Boom&Bust
                          At last I've managed to find a way of baking balloons that works.

                          I put 12 inch Gemar balloons that I got from Tesco inbetween two pieces of foil on a baking tray, pressed and bent the edges of the two sheets of foil together to get some sort of seal (the seal doesn't have to be perfect), then put them onto the second shelf in the oven, already preheated, at 140c no fan, for 18 minutes.

                          Once baked I will blow up the balloon and stretch the neck a little, then let it deflate and inflate only the neck a few times, then inflate the balloon again, they get quite huge and they're really soft and delicate, and when they pop they pop about half as loud as how loud they pop when not baked. They're pretty much the same as these balloons in this video. https://www.youtube.com/watch?v=DpTSKbvsqcI

                          For years I've wanted balloons just like those in the video, but could never find any, now I can make my own! In real life they look a lot more impressive than how they look in the photos.

                          On left is an unbaked one, and on the right is a baked one.

                          [ATTACH]2136[/ATTACH]

                          In this pic I had baked the yellow balloon on the right just like how I described above, except I had put it on the first shelf instead of the second in the oven, this made it get even bigger and softer, but when baking them this way some of the balloons (probably 4 out of every 10) can get a bit defective and pop when inflating.

                          [ATTACH]2137[/ATTACH]

                          Since ovens are different, you may need to tinker a little with the instructions I gave, like maybe not preheating the oven, or having the foil sheets not on a baking tray (which will make the chances of defects less likely, but the balloons wont get as big and soft), etc.

                          I will be receiving some 17 inch and 24 inch Tufftex balloons, I can't wait to try baking those, since they are a different brand the baking may not go as well, but hopefully it does.
                          Thank you so much for this tip! I’m trying it right now šŸ˜€


                          Comment

                          • srob2
                            Senior Member
                            • Dec 2017
                            • 552

                            #14
                            The problem is dealing with both time and temperature. If 18 minutes at 140c isn't enough, do I try 30 minutes at 140c or 18 minutes at 150c? I've gone through a lot of balloons just making smelly garbage.

                            Comment

                            • Alan
                              Senior Member
                              • Dec 2014
                              • 251

                              #15
                              A9DD036E-0BCE-4C3E-BF37-E96BB74DC7A6.jpg
                              It worked!! Left balloon is from 50 pack of 18ā€ balloon on the right was baked using your instructions. But these balloons have zero accidental pops. And amazing to hug after baking. Did burst with a deafening bang easily when my girlfriend rubbed it with her bare feet! Yep, she does not like me hugging balloons in bed šŸ˜‚

                              Comment

                              Working...