Necking balloons?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Lgcm
    Junior Member
    • Aug 2021
    • 27

    Necking balloons?

    Does necking a balloon cause it to become more fragile?

    I'm a semi-popper and love to see a neck when I ride... I'd just like to know if this means the balloon is at a higher risk of bursting

    Or any prevention tips for popping, I know a balloon will always be unpredictable, but I don't get aroused from the pop unfortunately.

    Thanks
  • Guest

    #2
    Re: Necking balloons?

    Hello! I am a non popper but I just love balloon necks, specially if it is big and tight.
    Now, I sincerely think that overinflation cause latex weakness but I also think that is part of the game.
    One advice is not inflate a lot big balloons like cattex 36 long neck and than ride hard on them to have a big and safe neck

    Comment

    • Asclepio
      Senior Member
      • Sep 2018
      • 539

      #3
      Re: Necking balloons?

      Usually a neck on a balloon means it is overinflated, so it is not that the balloon is weaker, it just just more air pressure against the latex so it can pop easier since the balloon is holding a lot more pressure than the let’s say this way “Normal” inflation.
      Unless the balloon is designed for necking (like the cattex longnecks) a necked balloon is closer to pop than a non necked one.
      A looner looking for fun, against violence or people with hightened moral idealism…. I just care about loons, so don’t ruin the fun.

      Comment

      • Lgcm
        Junior Member
        • Aug 2021
        • 27

        #4
        Re: Necking balloons?

        Originally posted by Teabag
        Hello! I am a non popper but I just love balloon necks, specially if it is big and tight.
        Now, I sincerely think that overinflation cause latex weakness but I also think that is part of the game.
        One advice is not inflate a lot big balloons like cattex 36 long neck and than ride hard on them to have a big and safe neck
        Thank you this is a really great tip. As a non-popper, what are the best durable balloons that you know of? i prefer them larger, but would love your opinion

        Comment

        • Lgcm
          Junior Member
          • Aug 2021
          • 27

          #5
          Re: Necking balloons?

          Originally posted by lyckr
          If you just want the neck to appear when riding the balloon and don't care if it's there when you're not sitting on it, just tie the knot or put on the clip as close to the mouthpiece as possible. That way you make room for air to be pushed into the neck from the body when you apply pressure to it.
          Thank you this is great advice!

          Comment

          • Common Loon
            Senior Member
            • Aug 2020
            • 232

            #6
            Re: Necking balloons?

            Great questions! Whether necking a balloon weakens it really depends on how the balloon was necked...

            After all, the neck of a round balloon is really a safety valve. It's a place for the air to go when the pressure inside the body of the balloon gets too high that the body can't stretch further to accommodate it. If you're just blowing up a balloon without any special technique or pre-stretching, having a neck appear doesn't mean the balloon is weakened -- to the contrary it means that the body of the balloon is strong enough to withstand enough pressure to sustain the (much smaller in diameter) neck inflation.

            On the other hand, if you neck a balloon by bouncing hard on it then sometimes the neck can weaken. Especially right at the end by the knot, if it develops a bowling pin-like bulge that's wider than the rest of the neck, this can be the weakest part of the balloon if you continue bouncing on it. After all, since balloons are dipped upside down, the latex on the neck is always a tiny bit thinner than the rest of the balloon, and the stresses of hard bouncing will focus right at the knot where the latex is gathered together.

            Comment

            • Lgcm
              Junior Member
              • Aug 2021
              • 27

              #7
              Re: Necking balloons?

              Originally posted by Common Loon
              Great questions! Whether necking a balloon weakens it really depends on how the balloon was necked...

              After all, the neck of a round balloon is really a safety valve. It's a place for the air to go when the pressure inside the body of the balloon gets too high that the body can't stretch further to accommodate it. If you're just blowing up a balloon without any special technique or pre-stretching, having a neck appear doesn't mean the balloon is weakened -- to the contrary it means that the body of the balloon is strong enough to withstand enough pressure to sustain the (much smaller in diameter) neck inflation.

              On the other hand, if you neck a balloon by bouncing hard on it then sometimes the neck can weaken. Especially right at the end by the knot, if it develops a bowling pin-like bulge that's wider than the rest of the neck, this can be the weakest part of the balloon if you continue bouncing on it. After all, since balloons are dipped upside down, the latex on the neck is always a tiny bit thinner than the rest of the balloon, and the stresses of hard bouncing will focus right at the knot where the latex is gathered together.
              This is a fantastic insight! thank you very much

              Comment

              • Guest

                #8
                Re: Necking balloons?

                I love large balloons as well, for a great neck I love cattex 36 long neck, but the absolute best for me are q24 if you can find any, the were absolutely the best for me

                Comment

                • Lgcm
                  Junior Member
                  • Aug 2021
                  • 27

                  #9
                  Re: Necking balloons?

                  Originally posted by Teabag
                  I love large balloons as well, for a great neck I love cattex 36 long neck, but the absolute best for me are q24 if you can find any, the were absolutely the best for me
                  The mystical q24... I am late to the balloon game and have heard they were incredible, many people's favourites.

                  I definitely missed out by the sounds of things.

                  But thank you for the longneck suggestion! I purchased 2 yesterday, so I'll be trying them out very soon

                  Comment

                  • Asclepio
                    Senior Member
                    • Sep 2018
                    • 539

                    #10
                    Re: Necking balloons?

                    The q24 balloons were good, but not that much either. It was a special balloon because of its big neck, but nothing that a longneck cattex can't cover perfectly. You didn't miss much, don't worry.
                    A looner looking for fun, against violence or people with hightened moral idealism…. I just care about loons, so don’t ruin the fun.

                    Comment

                    • LoonerHoax
                      Senior Member
                      • May 2020
                      • 521

                      #11
                      Re: Necking balloons?

                      I still prefer the Q24 over the Cattex long necks. For me the Cattex are too big once they get firm with a full neck. I also prefer the roundness of the Q24 over the flat paddle of the Cattex. Going to have to blow up a couple Q24's next week...

                      Comment

                      • FunLooner
                        Senior Member
                        • Dec 2019
                        • 877

                        #12
                        Re: Necking balloons?

                        If your interested I still have some Q24s that I can part with

                        Comment

                        Working...