Can I save it? (suggestion about how to restore a balloon)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • BLoon157
    Member
    • Oct 2020
    • 30

    Can I save it? (suggestion about how to restore a balloon)

    Hi everyone, I just saved an advertising balloon after the ending of a promotion, I deflated it and used the hair dryer for restore" the latex as best as possible, but I noticed that there is a tiny spot on it. (look picture)
    I think that if I try to blow it up again it burst, so, there is a way to "restore" it?
    Thank you idìn advice, have a nice day!
    Attached Files
  • balloonPatcher
    Senior Member
    • Jun 2020
    • 291

    #2
    Re: Can I save it? (suggestion about how to restore a balloon)

    If you have another balloon with thinner latex than the larger balloon, cut out a patch about 2-3 cm larger than the weak area. If you use latex that is as thick as the balloon the patch will not stretch well. Clean both the thin area on the balloon and the patch with a solvent. 99% alcohol or acetone. Coat both
    surfaces with rubber adhesive - I use a rubber tire cement. A bicycle patch cement will also work. Let the adhesive partially dry and press together.
    Let dry for about 1 hour. Repress and test by stretching the patch to see if it
    adhers. If it does not adher then reclean with solvent and recoat again with a fresh coat of adhesive. I attached a picture of the adhesive that is available
    in North America. The balloon is a 254 gram bladder that was old and the weak areas extensively patched. It was made by Bubble XL but they would not make anymore. Hope this helps.
    Mark
    Attached Files

    Comment

    • BLoon157
      Member
      • Oct 2020
      • 30

      #3
      Re: Can I save it? (suggestion about how to restore a balloon)

      Originally posted by balloonPatcher
      If you have another balloon with thinner latex than the larger balloon, cut out a patch about 2-3 cm larger than the weak area. If you use latex that is as thick as the balloon the patch will not stretch well. Clean both the thin area on the balloon and the patch with a solvent. 99% alcohol or acetone. Coat both
      surfaces with rubber adhesive - I use a rubber tire cement. A bicycle patch cement will also work. Let the adhesive partially dry and press together.
      Let dry for about 1 hour. Repress and test by stretching the patch to see if it
      adhers. If it does not adher then reclean with solvent and recoat again with a fresh coat of adhesive. I attached a picture of the adhesive that is available
      in North America. The balloon is a 254 gram bladder that was old and the weak areas extensively patched. It was made by Bubble XL but they would not make anymore. Hope this helps.
      Mark
      thank you very much, I would try that

      Comment

      Working...