Question cattex gl balloons?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Rik
    Junior Member
    • May 2026
    • 4

    Question cattex gl balloons?



    Hey, fellow Looners, how are you all? As it’s Friday again, do you have any plans for this weekend?

    A few days ago, I received the CATTEX GL1200, GL800, GL700, GL500 and a 70’’ round CATTEX balloon. I inflated them and gave them a go.

    I’d inflated one of the GL1200s to about 60–70 per cent, but it burst quite quickly after I lay down on it (I weigh 86 kilos and am 1.80 tall), even though they were described as indestructible, I thought?

    But does anyone here know from experience just how strong they are, or how far you can safely ride on them without them bursting? Does anyone have any tips on keeping them in the best possible condition? The first time, I pumped them up to 100 per cent and then let the air out until they were 60–70 per cent full. I’m hoping to get a bit more certainty!

    ​
    ​
  • Drewlooner
    Junior Member
    • May 2026
    • 29

    #2
    They are still balloons that may have had a defect that caused a pre mature pop. I have several gl500/700s that I've inflated multiple times and ride. I'm about 160lbs, and also inflated it 100% first time and maybe deflated down to 80-90%, and ride/hump, sometimes pretty vigorously or placing another balloon on top of the gl and riding that, and so far haven't had any accidental pops.

    However maybe not inflating it fully first caused an extra stress point where the balloon transitioned from the inflated portion to the un inflated. Or possibly just a defect like a weak spot in the body of it somewhere. I usually hold balloons I'm going to inflate in the light to see if there are any defects before inflating them. Sometimes it just happens they have a defect, not every one can be perfect.

    Comment

    • shrr1200
      Member
      • Aug 2021
      • 32

      #3
      Well, shit happens and even GLs are not indestructible. I have experienced faulty GL700s. I'm non popper, but two bursted while still being in the middle of inflation, one under my weight (I was probably too rough). But I have never had bursted GL1200, even though I have 110 kilos and sometimes even my wife on balloon.
      Use soft surface - mattress, blanket etc. Inflate it slowly and pre-stretch it with hands. Inflate just like to did to 70 % and you should be fine.

      Comment

      Working...