I would like to try baking balloons. But i dont know where to start. Can someone please tell me how to do it?
Hello together,
Collapse
X
-
Here's what I have done: I set the oven at 300 F. and baked for about 15 minutes. Part of the secret is to get even heat without anything touching any part of the balloon that is to be inflated. I accomplished this by taking a piece of cardboard and punching a hole in it and placing the very end of the neck of the balloon through the hole so that the balloon hangs down without touching anything. Put a piece of cardboard under your setup. It is much easer to throw out the cardboard than to clean the oven of melted latex! After removing allow to cool a couple of minutes then inflate. If the balloon is sticky it is over cooked and shorten the baking time till you get it rite. This worked well for me with Tuf-Tex 17s👍😎 3 -
Thanks for the tip. Did a couple today. I ended up dropping the temp after about 10 minutes to 285 F. Did it on convection with the balloons on parchment paper on a cookie sheet. Did a mixture of balloons and was only able to test a printed U16. The baked one was super soft, very fragile feeling but continued to take air, was also a little more elongated. Inflated an identical U16 without prestretching and it was 17.2" in DIameter, could've probably gone bigger but didn't want it to pop. The Baked balloon was 18.5" and certainly felt like it could take a lot more, thinking at least 22-24" in diameter. Can't wait to really push these all the way to bursting so I can see how big they will get,Here's what I have done: I set the oven at 300 F. and baked for about 15 minutes. Part of the secret is to get even heat without anything touching any part of the balloon that is to be inflated. I accomplished this by taking a piece of cardboard and punching a hole in it and placing the very end of the neck of the balloon through the hole so that the balloon hangs down without touching anything. Put a piece of cardboard under your setup. It is much easer to throw out the cardboard than to clean the oven of melted latex! After removing allow to cool a couple of minutes then inflate. If the balloon is sticky it is over cooked and shorten the baking time till you get it rite. This worked well for me with Tuf-Tex 17s👍🥰 1😎 1Comment
Comment