Warning up Latex??

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • king_of_loons
    Member
    • Jan 2023
    • 31

    Warning up Latex??

    Anybody have any tips or tricks on heating up loons?? It’s been real cold lately and i haven’t be able to get a good stretch on them.
  • balloonblower29
    Member
    • Sep 2024
    • 92

    #2
    I blow a little air into them (enough to fill the bulb. but not stretch it) and then heat them over the stove top. If you have huge balloons or a ton of them, toss them in the dryer on low heat, with some other clothes. No dryer? Try a hair dryer. It has been cold af here too lately so I feel you.

    Comment

    • lucid
      Senior Member
      • Sep 2016
      • 1174

      #3
      The best way I've found to quickly warm up latex balloons is to 1st fill them with extremely hot water. As hot as you're comfortable playing with that is. I don't use boiling water myself. I just put it in the tap and fill it with hot water. It works good enough without being too dangerous.

      How i found out this trick was extremely dangerous and stupid. I was much younger and had no access to a helium tank, but really wanted some floaty balloons. So I made some hydrogen... in my living room lol!
      Since I'm just a common, garden variety r-word, I'd not become familiar with how to properly do the chemistry. I wasn't prepared for the extreme heat and volatile chemical reaction that bellowed forth from my janky plastic bottle. I watched in absolute horror as the orange 17 inch balloon filled with a tiny bit of hydrogen, but mostly blistering hot steam and noxious fumes.

      Fortunately I was able to fill a pot with cold water and place the bottle in it using oven mitts before it melted down on the coffee table. I quickly ran the whole abomination outside and nervously watched it run the course of working its dirty magick.

      In the end, I was left with a near rated size balloon that barely floated. It probably would've had more life lift if it wasn't also full of steam and moisture. But the most notable thing was how stretchy and squeaky it was. You could press in at the widest part and your fingers would almost touch in the middle without it popping. I was mesmerized by it, but I was also afraid of it enough that I didn't take it back in the house. I feared if it popped it there, it would gas us.

      When my girlfriend smelled the melted plastic inside the house and then saw me outside with a melted plastic bottle and giant balloon, she yelled at me and popped the balloon with a long stick. She wasn't aware of my kink. I told her i was trying something I'd read in the Anarchist's Cookbook. Which is also actually true. There's something in there called a "Hindenburg B-mb".

      Overall, id rate this "science" experiment a 0 out of 5 stars.
      absolutely would not recommend.

      Just use hot water out of the tap.

      Comment

      • 7balloon
        One of the First Online
        • Dec 2018
        • 683

        #4
        next time you pull out laundry from the dryer, throw your balloons in the middle of the pile. its soft, general all around heat. do NOT use any fabric softener sheets in the dryer with that load.

        Comment

        • The Masked Looner
          Senior Member
          • Nov 2024
          • 179

          #5
          I never even think about warming up balloons before inflating them. I do however like to sometimes do an extreme version of warming them up which is basically baking them. Even once they have cooled down they will get really huge, soft, and fragile.
          Looning since 1989

          To see my pictures of prints and blown up examples: Printed Balloons - Balloon and Inflatable Fetish Forum​

          Comment

          • Mike D.
            Moderator
            • Mar 2020
            • 184

            #6
            I have used a hair dryer for years. It is also good to shrink down pre-stretched balloons to their normal size.

            Comment

            • loonlun
              Senior Member
              • Mar 2021
              • 410

              #7
              Not very often because I'm not sure about the risk of getting shocked, but a heated blanket underneath other blankets with balloons set on top for a bit can be fun.

              Comment

              • Dutch looner
                Member
                • Nov 2025
                • 31

                #8
                What i discovered is that a cheap heat gun also does the trick very well and can be a good alternative if you can't use the kitchen. I use the heat gun for a few minutes on its's low setting and hover some distance above the balloon. Just simply aply heat for as long as you desire.

                Comment

                • LoonzRebound
                  Senior Member
                  • Aug 2026
                  • 175

                  #9
                  I'd like to try the hot water bath with the balloons
                  I did try the hydrogen gas in the past with an orange 12, but that didn't really work and hydrogen smells bad.

                  I tried the heat gun, but that didn't really work.

                  Do you get the balloon cool down before inflating, or do it while warm?
                  Wumpkin Pumpkin

                  Comment

                  • Erthæl :3
                    Junior Member
                    • Sep 2026
                    • 25

                    #10
                    I don't get why people use hydrogen gas.
                    Seriously you do not want to explain that to the paramedics if you do survive. Never do anything you wouldn't want to explain to the paramedics

                    Comment

                    Working...