NYE balloon drop advice for phobic looner

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • theloonerboy
    Member
    • Mar 2024
    • 285

    #16
    OK - For those that are curious, here's what happened. .

    So when I arrived, I could see through from the outside of the building that the balloons were suspended in the net. This was a lounge/restaurant bar that was part of the rooms/buildings that surrounded the main ring/arena. The net wasn't that large. Once inside, I I checked in and signed the waiver for the risk of injury involved with skating. As the minutes went by, my social and balloon anxieties faded fast.

    After putting my water, jackets in the vestibule, I put on my helmet, and musical earplugs. I'm glad I did because the music was too loud for my taste. I measured it at 90db. Manageable for most, but not for me. With the plugs it was perfect, I could still enjoy the music.

    I was learning skating with quad skates that have two wheels per axle. I got the hang of it after an hour or so, that I was doing pretty much the average speed of the people there. Some were much faster and others much slower. I almost fell 3-4 times, but recovered. Balloon anxiety and social anxiety wasn't on my mind at all by this point.

    At the entry point of the ring,. they had 11-12 inch hanging columns (one on each side of the entrance for the ring) with a large silver balloon on top of each column. These were supported by a string from a pipe or a metal beam near the ceiling. The bottoms of the columns were close to the floor. Over the arena/ring, they had 24 inch? (not sure) balloons hanging from the ceiling. Just high enough that you could touch/or bat them with your arm raised above the head. Some people did it a couple of times lightly later in the evening. I was a little temped too, but didn't. Not because of the fear of balloons, but just because I didn't want to fall.

    So the DJ started saying about 5 mins before midnight to go to the lounge to see the balloon drop. No one skating at the ring did anything, they just kept skating. Same thing at the 90second mark, and even at the count down. I did the heard mentality and just kept skating..

    I was also nervous of going because the spectators were going there to watch the drop and the entrance to the lounge was too narrow for me. Also, I wasn't too confident to try to navigate on carpet with skates around people in case it was too intense for me. .

    So about five to ten minutes after midnight, maybe it was less than that, I started seeing some of the spectators returning and they had balloons. One kid was bouncing it and a guy in this 20's too. That's when I decided that the path was clear enough for me and I was about to enter the bar/lounge to look for balloons. A bouncer stopped me and said I needed a bracelet that was a different colour than the one I had. So I said "oh sorry".

    So when I returned I was looking to see if people would abandon their balloons and one person did!! There was a lady that was throwing a balloon in the air, then taking a selfie with the balloon in mi-air. After a few tries she got her shot and abandoned the balloon.. I soon got off the arena floor, went to the photo area and picked it up. I got back in the ring and for about 45 more minutes I skated with my balloon. My original mission was to keep at least one balloon and this was the only one I could get and it worked out fine!

    Based on this balloon and the other two I've seen, they didn't inflate them that tight for a drop. In fact, they were less tight then some that I inflated. The two others that people had were sliver and mine was a nice glossy black.

    I was very satisfied with my night and had a blast! I probably skated for 2.5 hours, taking a couple of breaks to drink water. For the whole night I might have heard a couple of pops. Once home, I inspected the balloon I rescued and noticed some clear finger prints; probably someone trying to squeeze pop it. There was a scuff as well. I also noticed a mysterious square mark on it which I figured was from a vape. I made sure not to touch my face since it looks like a bunch of people handled it.

    It looks of very nice quality because the latex is uniform when it's held in the light and it feels less stiff and more elastic than the Qualatex 11's. They look like the same size, maybe this balloon is a 12 inch.

    If you are interested, I can post a picture of it. After 19 days of popping desensitizing and a surprise pop at day 15, it's safe to say that I've earned my balloon!

    Comment

    • theloonerboy
      Member
      • Mar 2024
      • 285

      #17
      So the smaller black balloon is the one I "rescued" from the NYE roller skate event. It's probably an 11 or 12" balloon. This one was inflated to 8.5 inches and the balloons I was practice popping with were often 1-1.5 inches larger than this and much tighter. Seems like this black balloon has softer and stretchier latex than the Q-11's. I emailed the place and asked if they did the drop themselves or hired a decorator. They said that they did it themselves and they just used Party City balloons. I may buy a few balloons from the store I think they bought them from to test them out!

      I could tell the balloon resisted a lot of popping attempts and probably the people attempting them gave up or chickened out haha. There was a well defined finger squeeze mark, a skuff mark and some sort of a mysterious square imprint with rounded corners. Inside the square were a couple of circles that were a little larger than the diameter of a AA battery. At first I thought it could be a vape, but I'm not sure about this because I looked up some pictures and they don't look like what I've seen. It's probably the underside of the vape. and the circles were charging ports. A day after, I noticed a giant fingerprint that was multiple inches wide! That could be from the person that grabbed the balloon with greasy or sweaty hands before inflating it.

      So on Jan 2nd I inflated a nice trio of Belbal 14's as a celebration for the rescue and just the fact of going at the event. I even inflated a black belbal to the full 14 inches! Never have I inflated a BB to it's full size. It looked very nice with the neck I started. However, I soon popped it since I was afraid it would pop on it's own haha. The bang was similar to the Q-11's I was practising with. I regret not taking a picture of it but whatever. The 3 I inflated are no more than 12 inches. Based on my experience, if I go beyond this, they seem to pop on their own especially after light squeezing and some gentle batting. It's often many days after inflating them. Belbals have too many defects for my taste so I may try Tuftex when my stash gets low.

      This is probably the first time I post publicly balloon pictures of my own. I did post other balloon pictures, but only in private messages.
      Attached Files

      Comment

      • Nopops4me
        Senior Member
        • Jun 2015
        • 976

        #18
        Seeing any inflated balloons is a thrilling yours are included. The pink could've had a few more breaths to match the other two.
        ​​​​​

        Comment

        • lukmanrewa
          Senior Member
          • Jun 2012
          • 491

          #19
          Originally posted by theloonerboy
          So the smaller black balloon is the one I "rescued" from the NYE roller skate event. It's probably an 11 or 12" balloon. This one was inflated to 8.5 inches and the balloons I was practice popping with were often 1-1.5 inches larger than this and much tighter. Seems like this black balloon has softer and stretchier latex than the Q-11's. I emailed the place and asked if they did the drop themselves or hired a decorator. They said that they did it themselves and they just used Party City balloons. I may buy a few balloons from the store I think they bought them from to test them out!

          I could tell the balloon resisted a lot of popping attempts and probably the people attempting them gave up or chickened out haha. There was a well defined finger squeeze mark, a skuff mark and some sort of a mysterious square imprint with rounded corners. Inside the square were a couple of circles that were a little larger than the diameter of a AA battery. At first I thought it could be a vape, but I'm not sure about this because I looked up some pictures and they don't look like what I've seen. It's probably the underside of the vape. and the circles were charging ports. A day after, I noticed a giant fingerprint that was multiple inches wide! That could be from the person that grabbed the balloon with greasy or sweaty hands before inflating it.

          So on Jan 2nd I inflated a nice trio of Belbal 14's as a celebration for the rescue and just the fact of going at the event. I even inflated a black belbal to the full 14 inches! Never have I inflated a BB to it's full size. It looked very nice with the neck I started. However, I soon popped it since I was afraid it would pop on it's own haha. The bang was similar to the Q-11's I was practising with. I regret not taking a picture of it but whatever. The 3 I inflated are no more than 12 inches. Based on my experience, if I go beyond this, they seem to pop on their own especially after light squeezing and some gentle batting. It's often many days after inflating them. Belbals have too many defects for my taste so I may try Tuftex when my stash gets low.

          This is probably the first time I post publicly balloon pictures of my own. I did post other balloon pictures, but only in private messages.
          Yeah normally the balloons will be underinflated during a balloon drop to avoid them popping prematurely while they are hanging inside the net.

          Comment

          • theloonerboy
            Member
            • Mar 2024
            • 285

            #20
            Originally posted by Nopops4me
            Seeing any inflated balloons is a thrilling yours are included. The pink could've had a few more breaths to match the other two.
            ​​​​
            Yeah I noticed that too and thought the same a few minutes after I tied it haha. They are still alive and sitting pretty!

            Comment

            • Nopops4me
              Senior Member
              • Jun 2015
              • 976

              #21
              That's good to hear. Beautiful inflated balloons are much more useful than a popped balloon. Have fun with your balloons.

              Comment

              • theloonerboy
                Member
                • Mar 2024
                • 285

                #22
                Originally posted by lukmanrewa

                Yeah normally the balloons will be underinflated during a balloon drop to avoid them popping prematurely while they are hanging inside the net.
                This is just based on the many balloon drop videos I've seen. Most of them are inflated fully and many are very overinflated. So much so that very often when the nets or shaken to release the balloons, some will pop on their own in the net.

                I read somewhere that it's better to overinflate them to prevent fall hazards. If someone steps or attempt to pop a balloon, an overinflated one will pop rather than roll and potentially make you fall.

                The drop I went to was prepared by the venue and not a decorator, so this could explain why the balloons weren't quite full.

                Comment

                Working...