Balloon mods

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • mrmoo47
    Junior Member
    • May 2025
    • 12

    Balloon mods

    So after going down the rabbit hole of balloon mods/alterations, I took it upon myself to try to alter a cattex 32” into a geo/sph. (Using rubber cement) With limited success at first I managed to get the sph to adhere properly, but it was not aligned central. Therefore didn’t inflate correctly.

    does anyone have any experience with things like this? Any tips or advice would be greatly appreciated.

    thanks!
  • balloonPatcher
    Senior Member
    • Jun 2020
    • 291

    #2
    Check out the thread of some balloon modifications.

    Comment

    • cl23
      Senior Member
      • May 2022
      • 381

      #3
      For testing a new method, i made this miniature model from two 12" balloons (much too small for usage, but looks cool):

      d12.jpg d13.jpg
      I made it this way...
      d10.jpg
      ... that turns into this after turning it inside out:
      d9.jpg
      I drew points at the central side points of the main balloon with a pen to ensure the holes for the inner balloon get into the right spot.

      Comment

      • cl23
        Senior Member
        • May 2022
        • 381

        #4
        It's not very important for the holes in the main balloon to be perfectly round, but you should try to get close to it.
        I pinch a bit of latex at the place where the hole should be and cut it off with scissors.

        Comment

        • Gunnapop
          Senior Member
          • Oct 2020
          • 215

          #5

          Comment

          Working...