Random holes appearing

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Loon119
    Senior Member
    • Jun 2018
    • 494

    Random holes appearing

    Had my last " happy burstday" balloon from balloons united in a nice red. Blew it up last week for my birthday. Placed it safely on my bed this morning, went and had a shower came back and it was flat. There's a small pin sized hole in it absolutely gutted it's been fine all week and literally in a few minutes flat as anything
  • SweetBouncer
    Senior Member
    • Mar 2020
    • 218

    #2
    With a bit of costume liquid latex you can pathch it, just buy it in a dollar store or costume store, they should have some stock left grom halloween, the best time to buy as stock is plenty. Just cover the hole with latex, liquid or cream, using a q-tip, then blats it with a hair dryer, a bit of talc of cornstarch once the latex becomes hard and yellowy to prevent sticking and is as good as new.

    Comment

    • Loon119
      Senior Member
      • Jun 2018
      • 494

      #3
      I mentioned the hole to the wife. We are putting it on the pump and seeing how big it will go before popping.
      Good job I trust her to pop

      Comment

      • robbirdin
        Member
        • Jun 2021
        • 49

        #4
        are you sure its random and not due to some prior defect? in my experience some larger defects tend to rupture and turn into holes with inflation which can result in pop or just deflated balloon depending on tightness or location od the defect

        Comment

        • Loon119
          Senior Member
          • Jun 2018
          • 494

          #5
          It's possible I did check it carefully during inflation as it's quite an oldish balloon but there were no obvious flaws or thin patches. It inflated just like a brand new balloon, necked lovely. It's been around about a week no issues at all. Went to have a shower came back and it was flat. The wife said it was literally inflated when she went to look into the mirror as she looked at the balloons on the bed and then we looked all over the balloon finally finding a small pin hole. I managed to untie it and said it was a waste because I wanted it to pop during some really mind blowing fun. I said I wondered if it would reinflate, retie and pop before it went down and then the wife suggested just put it on the pump so it will pop during fun and it's a great idea if not quite stressful as I'm still phobic but she's really good at popping

          Comment

          • Loon119
            Senior Member
            • Jun 2018
            • 494

            #6
            Absolutely hated that. Pump to pop is the worst thing I've ever been part of. I saw the hole get bigger and saw the balloon shredding just before the huge bang. Triggered my phobia something awful never popping like that again

            Comment

            • lucid
              Senior Member
              • Sep 2016
              • 1174

              #7
              I know alot of times after repeated inflations when the latex gets super blown out, tiny holes can form in it like that. Not sure if that's what happened here, but ive seen it happen.

              Comment

              Working...