I have found a different way of permanently tying off balloons using scraps of 160 twisting balloons. I can't find anything about this online.
This works best with necked balloons, but should work with others. Just twist your desired balloons mouthpiece a few times, and secure it with the 160 scrap.
I find myself using this method for balloons that tend to tear and rip easily when being tied, or if the balloon is so full that it can't be tied normally.
I have included a photo of what this should look like for reference. It has been done to a 12" balloon, but most smaller to medium sizes should work fine. I am unsure on larger sizes.
This works best with necked balloons, but should work with others. Just twist your desired balloons mouthpiece a few times, and secure it with the 160 scrap.
I find myself using this method for balloons that tend to tear and rip easily when being tied, or if the balloon is so full that it can't be tied normally.
I have included a photo of what this should look like for reference. It has been done to a 12" balloon, but most smaller to medium sizes should work fine. I am unsure on larger sizes.
Comment