Designing balloon tying tool

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Guest

    Designing balloon tying tool

    Recently I was trying to make a balloon room with super overinflated, fully necked balloons. But just after tying several balloons, my fingers started to feel really sore. I can use valves or clips instead, but unfortunately I don't have enough stocks for the full balloon room. So I'm trying to find a way to easily tie these super overinflated balloons.

    I tried the common knot-tying tools available on the market, but I need to pull the neck really long to make a ring, so it's only good for standard-sized balloons with enough uninflated neck room.
    image.png
    There are also YouTube videos that say you can use a fork to tie knots. However, when you make the ring with it, it's difficult to put the end into the ring.

    Then I realized that maybe I can make a smaller version of the tying tool, so I cut a small piece of soft tubing, but it was too soft.
    image.png
    After that I made a simple model and 3D printed it. It'll be delivered next week, and I'll try if it works.
    image.png
  • Guest

    #2
    Actually, besides using the tying tool, you can use a rubber band or broken balloon to tie a single overinflated balloon. However, For tying two overinflated balloons together, I didn't find a good method. Do you have any experience?

    Comment

    • phenix
      Senior Member
      • Jan 2021
      • 349

      #3
      I use a regular rubber band
      Attached Files

      Comment

      • AlterPlatzer
        Senior Member
        • Jun 2024
        • 1528

        #4
        I've tied thousands of balloons with only my fingers. I've found these tying tools to be clumsy.

        It's OK to love balloons.
        There are as many differences in preferences as there colors of balloons. Accentuate what makes us the same and not what sets us apart.

        Comment

        • bigloonfucker.cz
          Punk member
          • Nov 2023
          • 145

          #5
          Originally posted by phenix
          I use a regular rubber band
          Same as me, when I tie my loon with plastic clip, i am afraid it will turn a sharp edge against baloon while I ride balloon wild. I always cut popped loons lips...
          The softer balloon the better. When not soft enough, I bake him untill success

          Comment

          Working...