A long while back I was able to acquire quite a few Qualatex 18" gold Happy New Year balloons that I really like. I've stored them carefully and used a few each year to celebrate New Year's Eve but last year and this year they popped after just a few breaths and I'm wondering if this is because of the way the imprinted areas of the balloon stretch versus the bare latex. These aren't the thin imprints like advertising balloons but rather the kind that have a design that almost looks like icing piped on the balloon. It feels a little raised on the uninflated balloon but normally flattens out as you reach the rated size. Does this make sense? The imprint seems to be more ON the balloon than IN the latex. I have other regular 18" Qualatex of the same vintage in plain latex, jewel tone, and crystals and they're just fine, like a brand-new balloon when first inflated and for several years the imprints were the same. Is it normal for the imprints to degrade while the non-imprint latex stored the same way are fine? It seems that my New Year balloons are all ready to give up with the smallest amount of stretching and pressure even though they're nowhere near their rated size. Is it time to give up on them?
Do imprints stored correctly degrade faster than regular balloons?
Collapse
X
-
Unfortunately, Qualatex partially used some white balloon ink, that destroyed the printed balloons after a few years. I also have a few hundred Q16 and Q18, that now are unusable and cannot be restored (as e.g. hardened balloons). They also used a different white balloon ink, that did not had an impact on the degradation.
It depends on the print. I had some dark blue Q16 with the old German "Quelle"-Logo from the late 90s. They were about 20 years old and inflated perfectly fine, big and tight.
-
I've noticed a similar thing lately too. My guess is that for printed balloons, the printed parts are at least somewhat thicker than the rest of the balloon, creating fairly sharp transitions in thickness at the border of the prints. As the latex ages I wouldn't be surprised if those transition areas become potential failure points because you have a bit that's easier to stretch (non-printed area) abutting a bit that's harder to stretch (printed area). Also, the print itself isn't vulcanized like the latex of the balloon itself, so it would tend to age differently. I'm sure the specific composition of the latex used for printing matters too, as qualatex prints tend to be pretty "dense" in the sense that you get really nice uniform pigmentation across the print, as opposed to the thinner prints on, say, cattex balloons.Comment
Comment